Abstract:The three-dimensional (3D) microstructure of neutron-irradiated uranium-10 wt.% molybdenum (U-10Mo) fuel with a burn-up of 9.8×10 21 fissions/cm 3 was characterized using a novel, multi-modal synchrotron micro-computed tomography approach combining propagation-based phase-contrast enhanced and absorption contrast techniques. The porosity development, porosity interconnectedness, swelling, composition, local thickness of the zirconium (Zr) diffusion barrier, and the influence of the fuel–cladding interaction on the local composition and pore morphology, were uniquely determined in 3D. Two cuboids were produced using a focused ion beam-scanning electron microscope at the Zr diffusion barrier–fuel interface and in the bulk fuel. The bulk fuel sample swelled by 53.3[+9.7/-3.1]%, while the fuel near the Zr–fuel interface swelled by 63.3[+14.7/-7.2]%. The average local thickness of the Zr diffusion barrier decreased by 53%, compared to the expected pre-irradiated thickness. Four pore morphology regions were identified initiating parallel to the fuel–Zr interaction region: (1) an interaction layer of suppressed porosity, (2) a layer of elongated and interconnected porosity, (3) a transition zone of low porosity, and (4) a layer of unoriented porosity representative of the bulk fuel behavior. The increase in porosity near the diffusion barrier corresponded to a higher U concentration compared to that in the bulk fuel. The interconnected porosity in the fuel near the diffusion barrier was extensive and oriented parallel to the diffusion barrier, while the bulk fuel had more compact and isolated pore networks. The interaction layer, despite having suppressed porosity, was nearly 100 wt.% U. Porosity suppression at the diffusion barrier corresponds to the expected reduction in radiation-driven diffusion of Xe at the interface despite the anticipated increase in fission product nucleation originating from a higher U concentration. The novel 3D insights of the porosity, swelling, and compositional variations characterized herein can improve the fidelity of fuel performance codes for proliferation-resistant fuels for research and test reactors.

Application of wavelet scaling function expansion continuous-energy resonance calculation method to MOX fuel problem

Thermo-mechanical Behavior Simulation Coupled with the Hydrostatic-Pressure-dependent Grain-Scale Fission Gas Swelling Calculation for a Monolithic UMo Fuel Plate under Heterogeneous Neutron Irradiation

Verification of VSOP Model for Plutonium Fuel Core Based on Monte Carlo Method

Dataset of observables for UOX and MOX spent fuel extracted from Serpent2 fuel depletion calculations for PWRs

Feasibility analysis of the Sanchez-Pomraning method to treat the particle size distribution in particle-dispersed fuel

Possibilities of Better Utilization of MOX fuel in VVER type reactors by optimizing neutron spectrum

Study of Minor Actinides Transmutation in PWR MOX fuel

Feasibility Study on the Analysis of MOX Particle Behavior

Atomic Simulations of U-Mo under Irradiation: A New Angular Dependent Potential

Resonance Calculation of FCM Fuel Based on the Global-Local Method

The pore aggregation characterized by spatial statistics methods and its effect on the damage behavior based on the configurational forces of the M -integral in MOX fuel

Research on Preventing Xenon Oscillation in Monte Carlo Burnup Calculation Based on RMC

NEUTRONIC CALCULATION FOR PWR MOX FUEL PIN CELLS WITH WIMSD-5B CODE

Neutron Cross Section Generation for PWR MOX Fuel Assemblies with SCALE and Serpent

Transmutation Study of Minor Actinides in Mixed Oxide Fueled Typical Pressurized Water Reactor Assembly

Neutronic Evaluation of LWR Based SMR with TRU Fuel and Comparison with Different Core Configuration of UO2 and MOX Fuel

Atomic simulations of primary irradiation damage in U-Mo-Xe system

Synchrotron Micro-Computed Tomography Analysis of Neutron-Irradiated U-Mo Fuel

Multidimensional multiphysics simulations of the supercritical water-cooled fuel rod behaviors based on a new fuel performance code developed on the MOOSE platform

Monte Carlo simulation of dispersed coated particles in accident tolerant fuel for innovative nuclear reactors

Possible ways to solve the problems of using MOX fuel in thermal reactors