Reforming and Adjustment of Biomass Fuel Gas over Ni-based Monolithic Catalyst

LI Kai,DING Ming-yue,LI Yu-ping,WANG Tie-jun,WU Chuang-zhi,MA Long-long
DOI: https://doi.org/10.3969/j.issn.0253-2409.2012.06.009
2012-01-01
Abstract:The Ni-based monolithic catalyst was prepared by impregnation method.The performance of the catalyst on biomass fuel gas reforming was investigated by varying the reaction temperature,space velocity,steam addition and time-on-stream.Results show that the Ni-based monolithic catalyst exhibited only CO hydrogenation activity as the reaction temperature is lower than 500 ℃.With the increase in reaction temperature,the reforming activity increased gradually.The CH4 or C2 conversion was above 95%,and CO2 conversion was about 92 % over the catalyst at higher temperature(≥800 ℃).However,increasing space velocity and the addition of water steam resulted slightly in the decrease of reforming activity.Additionally,with increasing water steam content the H2/CO volume ratio in synthesis gas increased gradually from 0.85 to 4.00.According to the characteristic of X-ray diffraction,it was found that the formation of Nio could promote well the reforming reaction.
What problem does this paper attempt to address?