Abstract:The membrane electrode assembly (MEA) is a critical part of proton exchange membrane fuel cells (PEMFCs) and has a significant impact on their performance. A novel preparation method of MEA is proposed in this work to inhibit the swelling and deformation of the proton exchange membrane (PEM) during MEA preparation and improve the interface between the PEM and cathode catalyst layer (CL). Using this novel fabrication method, an asymmetric MEA is prepared, where the anode and cathode parts are fabricated separately and then integrated by a hot-pressing process. The cathode part is prepared by covering the gas diffusion electrode (GDE) onto a layer of a perfluorosulfonic acid dispersion to form a membrane-coated electrode according to a wet-contact interface design, thereby ensuring a tight and concave-convex PEM/CL interface on the cathode. The anode part is prepared by spraying the CL onto a commercial PEM with a substrate to form a CL-coated PEM. An MEA was also prepared according to the traditional catalyst-coated membrane (CCM) method for comparison. The asymmetric MEA based on the new manufacturing process performs better than the traditional CCM-type MEA under the same PEM thickness prerequisite. The peak power densities of the asymmetric MEA are verified to be 18% (H2/ air) and 31% (H2/O2) higher than conventional CCM-type MEA. In addition, the asymmetric MEA shows less cell performance degradation after 3000 dry/wet test cycles than the CCM-type MEA.

Self-humidifying membrane electrode assembly prepared by adding PVA as hygroscopic agent in anode catalyst layer

Membrane Electrode Assembly with Pt/SiO2/C Anode Catalyst for Proton Exchange Membrane Fuel Cell Operation under Low Humidity Conditions

Modifying the Catalyst Layer Using Polyvinyl Alcohol for the Performance Improvement of Proton Exchange Membrane Fuel Cells under Low Humidity Operations

A Novel Self-Humidifying Membrane Electrode Assembly with Water Transfer Region for Proton Exchange Membrane Fuel Cells

Novel self-humidifying MEA with water transfer region for PEM fuel cells

A novel preparation for a self-humidifying membrane electrode assembly and performance of its fuel cell

High-performance Membrane Electrode Assembly with Multi-Functional Pt/SnO2–SiO2/C Catalyst for Proton Exchange Membrane Fuel Cell Operated under Low-Humidity Conditions

Dual-functional phosphoric acid-loaded covalent organic framework for PEMFC self-humidification: Optimization on membrane electrode assembly

Self-humidification of a PEM fuel cell using a novel Pt/SiO2/C anode catalyst

Designing self-humidifying proton exchange membrane fuel cells by using patterned acid-alkaline hybrid cathodes

Proton Exchange Membrane Fuel Cell with Humidifying Zone

Ultrahigh PEMFC performance of a thin-film, dual-electrode assembly with tailored electrode morphology

Self-Humidifying Membrane Electrode Assembly Prepared by Adding Microcrystalline Cellulose in Anode Catalyst Layer As Preserve Moisture

Improvement of proton exchange membrane fuel cell performance in low-humidity conditions by adding hygroscopic agarose powder to the catalyst layer

An Asymmetric Membrane Electrode Assembly for High-Performance Proton Exchange Membrane Fuel Cells

Designing Membrane Electrode Assembly for Weakly Humidity-Dependent Proton Exchange Membrane Fuel Cells

Preparation of an Integrated Membrane Electrode Assembly for Proton Exchange Membrane Fuel Cells Using a Novel Wet-Bonding Strategy

The Performance of H2/air Self-Humidifying MEA for PEMFC

The buffer microporous layer improved water management for proton exchange membrane fuel cell at varying humidification

Enhanced MEA Performance for an Intermediate-Temperature Fuel Cell with a KH5(PO4)2-Doped Polybenzimidazole Membrane

Development of Cathode Ordered Membrane Electrode Assembly Based on TiO2 Nanowire Array and Ultrasonic Spraying