Abstract:Mechanism experiments were performed to investigate NO x formation and reduction during the combustion of high-ash, low-volatile coal. Additionally, industrial-scale trials were conducted to study the effects of air-staging degree on the combustion and NO x emission characteristics of high-ash coal on a 350 MW supercritical down-fired boiler. The results showed that the total BET specific surface area, total pore volume and porosity values of high-ash coal (HAC) and ultra-high-ash coal (UHAC) were all larger than those of normal-ash coal (NAC), whereas NAC contained more N-5 and N-6 than HAC and UHAC. The carbon layer structure of HAC char was less ordered and the content of hydroxyl group was relatively high. The overall NO reduction ratio obtained using the HAC char was higher than the value for the UHAC char. However, in the high temperature range of 1300–1400 °C, NO reduction associated with UHAC char was accelerated because of catalysis by ash. On increasing the excess oxygen ratio λ from 1.0 to 1.2, the char-N conversion shown by the UHAC char slowly increased and remained the lowest among the three chars. When burning UHAC, as the ratio of secondary to tertiary air fluxes, R st , was decreased from 1.56 to 0.57, heating of the fuel-rich coal/air flow slowed and pulverized coal combustion was inhibited. The situation associated with HAC was different. At the R st of 1.11, the ignition distance of fuel-rich flow was the shortest at 1.50 m, and the overall temperature in the furnace was the highest. However the NO x emissions at the furnace exit were as high as 715 mg/m 3 (6 % O 2 ) in this condition. Decreasing R st to 0.57 reduced this value to 634 mg/m 3 (6 % O 2 ) with carbon levels in the fly ash and slag of 5.17 % and 3.67 %, respectively. Air-staging combustion is evidently a reasonable approach to controlling NO x emissions when burning HAC. While for UHAC, it was necessary to appropriately reduce the air-staging degree to enhance combustion and maintain low NO x emissions.

Effect of Coal Ash on NOx Emission of CFB Boilers

Effect of Adding MMT to the Coal on Carbon Content in Fly Ash and the NOx Emission

Effects of Na and Fe on the Formation of Coal-Derived Soot in a Two-Stage Flat-Flame Burner

Experimental Study of Effects of Pulverized Coal Characteristics on the Conversion of Fuel Nitrogen to NOx

Effect of Circulating Ash from CFB Boilers on NO and N2O Emission

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Experimental Investigation of the Effects of Circulating Ash from CFB Boilers on NO and N_2O Emissions

Experimental Study on the Influence of Operating Parameters on NOx and N2O Emissions During Co-Firing of NH3 and Coal in a CFB

Experimental Study of NH3 and Coal Co-firing in a CFB and Its Nitrogen Conversion

Experiments on effects of coal particle ash content on ash formation during fluidized bed combustion

Effect of calcium-based additives on NO release of coals under different combustion modes

An Experimental Study on N2O Reduction over Circulating Ashes of CFB Boilers

Conversion of Fuel-N to N2O and NOx During Coal Combustion in Combustors of Different Scale

Studies on NO x formation and reduction characteristics in high-ash, low-volatile coal combustion by mechanism experiments and industrial-scale trials

Experimental Study on the Effect of Circulating Ashes on Ammonia Oxidation

Investigation of Ash Deposition Characteristics in Full-Scale Circulating Fluidized Bed Boiler Burning Zhundong Coal

Role of Carbide Slag Addition on NO Emission Characteristics During Coal Combustion

Effect of Al2O3/CaO on the melting and mineral transformation of Ningdong coal ash

Experimental Study of Effect of a Novel Ammonia/coal Co-Firing Mode on NOx Emission under High Temperature Conditions

Effects of Co-Firing Biomass and Pulverized Coal on NO Reduction in Cement Precalciner

Experiments on the Effect of Chemical Components of Coal Ash on the Sintering Temperature