Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

Effects of Surface Electrochemical Pretreatment on the Photoelectrochemical Performance of Mo-Doped Bivo4

Enhanced the Performance of Photoelectrochemical Oxidation of Water over Bivo4 Film Electrodes by Electrochemical Reduction Pretreatment

Enhancing Mo:BiVO4 Solar Water Splitting with Patterned Au Nanospheres by Plasmon‐Induced Energy Transfer

Surface Modulation Inducing Bismuth-Rich Surface Composition in BiVO 4 for Efficient Photoelectrochemical Water Splitting

Fabrication of electrochemically-modified BiVO

Electrochemical Creation of Surface Charge Transfer Channels on Photoanodes for Efficient Solar Water Splitting

The hydrophilic treatment of a novel co-catalyst for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

In Situ Photoelectrochemical‐Induced Surface Reconstruction of BiVO4 Photoanodes for Solar Fuel Production

Electron polarons in the subsurface layer of Mo/W-doped BiVO4 surfaces

Mo or W Doping into the Surface of BiVO4 Film Photoanodes Through a Photoelectrochemical Treating Approach for Efficient Solar Water Oxidation

Effects of Fluorination and Molybdenum Codoping on Monoclinic BiVO Photocatalyst by HSE Calculations.

Photoelectrochemical Performance Improving Mechanism: Hybridization Appearing at the Energy Band of BiVO 4 Photoanode by Doped Quantum Layers Modification

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

The promotion effect of surface negative electrostatic field on the photogenerated charge separation of BiVO4 and its contribution to the enhanced PEC water oxidation.

Direct Liquid Injection Chemical Vapor Deposition of Molybdenum-Doped Bismuth Vanadate Photoelectrodes for Efficient Solar Water Splitting

Unconventional Relation between Charge Transport and Photocurrent via Boosting Small Polaron Hopping for Photoelectrochemical Water Splitting

Improved Surface Charge Transfer in MoO3/BiVO4 Heterojunction Film for Photoelectrochemical Water Oxidation

Correlation between Dynamics of Polaronic Photocarriers and Photoelectrochemical Performance in Mo-Doped Bismuth Vanadate

Synergy Effect of the Enhanced Local Electric Field and Built-In Electric Field of CoS/Mo-Doped BiVO4 for Photoelectrochemical Water Oxidation.

Revisiting the photocharging effect on the BiVO4 (010) surface by identifying the charge reaction kinetics

Interfacial Engineering‐Assisted Energy Level Modulation Enhances the Photoelectrochemical Water Oxidation Performance of Bismuth Vanadate Photoanodes