Abstract:The elastic stress and strain fields in a plate of finite thickness containing an elliptical hole are systematically investigated using the 3D finite element method. It is found that the stress and strain concentrations are different in the plate of finite thickness even if the plate is in an elastic state. The relation between the stress and the strain concentration factors depends on Poisson’s ratio, the hole’s geometric configuration and the plate thickness. The stress concentration factor is equal to the strain concentration factor only at the notch root of the plate surface. The stress (or strain) concentration factor at the notch root of the plate surface decreases rapidly with increasing thickness and becomes lower than the stress and strain concentration factors corresponding to the plane stress state or at the notch root of the mid plane. It is too low to reflect the overall stress concentration as the thickness increases or as the b/a ratio decreases. The maximum stress concentration factor occurs on the mid plane only when the plate is thinner than the transition thickness of the stress concentration factor. When the plate is thicker than the transition thickness of the stress concentration factor, the distance between the location of the maximum stress concentration factor and plate surface tends to be constant with increasing thickness for the plate with a given b/a ratio. The differences between the maximum value and the surface value of the stress and strain concentration factors increase rapidly and tend to their respective constant values with increasing plate thickness. The smaller the b/a ratio, the larger these differences. The difference of the stress concentration factor is larger than that of the strain concentration factor in the same plate.

Stress and strain concentrations in finite-thickness rings under diametrically opposite external loads

Stress and strain concentrations for the filleted shafts in tension

The Coupled Effects of Thickness and Distance Between Holes on Stress and Strain Concentrations of Uniaxially Loaded Tensile Plates

The Stress and Strain Concentrations of an Elliptical Hole in an Elastic Plate of Finite Thickness Subjected to Tensile Stress

On the response of postbuckling of rings with strain hardening under external pressure

The Stress and Strain Concentrations in Curved Beams of Finite Thickness with End Moments

Stress and Strain Concentrations in an Elasto-Plastic Bar of Circular Cross-Section with Semicircular Groove

The concentration of stress and strain in finite thickness elastic plate containing a circular hole

Finite Element Analysis of Ring Strain Sensor

The Stress and Strain Concentrations Associated with Two Interacting Holes in A Finite Thickness Elastic Plate Subjected to Tensile Stress

The size effect on the concentration of stress and strain in finite thickness elastic plate containing a circular hole

Finite Element Method and Experimental Investigation on the Residual Stress Fields and Fatigue Performance of Cold Expansion Hole

On the Study of Stress-Strain of Thin-Walled Cylinder Tensile Specimens at High Temperature

On the Reduction of Stress Concentrations in Thick-Walled Hollow Spheres under an Arbitrary Uniform Axial Symmetric Outer Traction

Analytical solutions of stress distribution within a hollow cylinder under contact interactions

Novel Ring Compression Test Method to Determine the Stress-Strain Relations and Mechanical Properties of Metallic Materials

The Stress and Strain Concentrations of Out-of-plane Bending Plate Containing a Circular Hole

Stress and Strain Concentrations in an Elastic Bar of Circular Cross-Section with Semielliptic Groove Subjected to Tension

The Effect of Biaxial Load on Stress and Strain Concentrations in a Finite Thickness Elastic Plate Containing a Circular Hole

An exact analytical solution for stress concentrations within layered hollow spheres under compression

The Interaction of Holes on Stress and Strain Concentrations in Uniaxially Loaded Tensile Plates