Abstract:In reinforced concrete design, seismic provisions outline three types of moment resisting frames for use in high, moderate, and low seismic regions. However, there has been no methodology for assessing the performance of these structures other than through observations from actual seismic events or physical testing. The Applied Technology Counsel (ATC) has developed the ATC-63 Methodology (now FEMA P695) for assessing the seismic performance of structures through mathematical simulation, which may be used to assess the performance of reinforced concrete frames. This study investigates the performance of reinforced-concrete intermediate moment frames (IMF) used in moderate seismic zones. In this study, a four-story and six-story IMF were designed; once using current American Concrete Institute (ACI) seismic provisions and again with the addition of a strong-column weak-beam ratio. The earthquake simulation and dynamic analysis software OpenSees was then used to model the frames and analyze their structural performance. The ATC-63 Methodology as outlined in FEMA P695: Quantification of Building Seismic Performance Factors was used to assess the performance, focusing namely on the IMF's median collapse capacity, in terms of spectral acceleration. Three major findings applicable to IMFs of the type and height modeled were produced from the study. First, the results indicate that the current IMF provisions of ACI-318 2008 do provide acceptable seismic performance. Second, the addition of a strong-column weak-beam ratio did not offer significant improvement over current provisions. Third, the study indicates a potential concern for shear failure occurring that the models would not detect. Further investigation is needed to address this concern. These results add insight into the design provisions for intermediate moment frames and contribute to the technical base for future criteria and study.

A Method for Determination of Seismic Target Performance Level of Reinforced Concrete Frames

Behavior and Design of Earthquake Resistant Concrete Structure

Performance-Based Seismic Design and Evaluation of Fused Steel Diagrid Frame

An efficient method for optimizing the seismic resistance of reinforced concrete frame structures

STUDY ON THE COLLAPSE-RESISTANT CAPACITY OF RC FRAMES WITH DIFFERENT SEISMIC FORTIFICATION LEVELS

A Performance-Based Design Approach for Rectangular Concrete-Filled Steel Tube (RCFT) Frames under Seismic Loading

Seismic reinforcement analysis and measurement research of reinforced concrete frame structure

A two-level performance-based plastic design method for multi-story steel frames with double-yielding systems

Seismic Design Methodology Based on Damage Mechanism Control for Reinforced Concrete Structures

Case Study on the Seismic Performance of Reinforced Concrete Intermediate Moment Frames Using ACI Design Provisions

Seismic design and analysis of reinforced concrete buckling-restrained braced frame buildings with multi-performance criteria

Performance-based versus conventional seismic design: comparative assessment on a 4-story RC moment frame

Design earthquake level analysis for high dams

Analysis on design parameters of seismic performance based on damage for recycled aggregate concrete-filled steel tube column

Performance‐Based Seismic Design With Consideration of Safe Storage From Errors in Reinforced Concrete Member Estimated Yield Deformation

Influence of Structural Parameters to the Seismic Collapse Resistance of RC Frames in 7-degree Seismic Fortification Zone

Value based seismic design of structures using performance assessment by the endurance time method

Performance-based-plastic-design of damage-control steel MRFs equipped with self-centring energy dissipation bays

Seismic loss comparison of typical high-rise buildings in China and USA using the new-generation performance-based design method

Study on Evaluating the Seismic Performance of Building According to Detail Seismic Condition

Seismic vulnerability of prefabricated reinforced concrete frame structure based on local outsource steel tube bolted column–column connection