Abstract:Over the past 20 years, as the depth and diameter of shaft lines increased in China, the cracking and water leakage of the inner walls of frozen shafts have become increasingly severe, resulting in significant safety threats and economic losses. Understanding the stress variation patterns of cast-in-place inner walls under the combined effects of temperature and constraint during construction is a prerequisite for evaluating the crack resistance performance of inner walls and preventing water leakage in frozen shafts. The temperature stress testing machine is an important instrument for studying the early-age crack resistance performance of concrete materials under the combined effects of temperature and constraint. However, existing testing machines have shortcomings in terms of applicable specimen cross-sectional shapes, temperature control methods for concrete structures, and axial loading capacity. In this paper, a novel temperature stress testing machine suitable for the inner wall structure shape, capable of simulating the hydration heat of the inner walls, was developed. Then, a reduced-scale model of the inner wall according to similarity criteria was manufactured indoors. Finally, preliminary investigations of the temperature, strain, and stress variations of the inner wall under 100% end constraint conditions were conducted by simulating the actual hydration heating and cooling process of the inner walls. Results show that the hydration heating and cooling process of the inner wall can be accurately simulated. After approximately 69 h of concrete casting, the accumulated relative displacement and strain of the end-constrained inner wall model were −244.2 mm and 187.8 με, respectively. The end constraint force of the model increased to a maximum value of 1.7 MPa and then rapidly unloaded, causing the model concrete to crack in tension. The temperature stress testing method presented in this paper provides a reference for scientifically formulating technical approaches to prevent cracking in cast-in-place concrete inner walls.

Interface shear behavior of a shaft lining concrete-high density polyethylene material under different pre-imposed normal stresses

Interface Failure of Segmental Tunnel Lining Strengthened with Steel Plates Based on Fracture Mechanics

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Shear-friction behavior of concrete-to-concrete interface under direct shear load

SHEAR STRENGTH ON THE INTERFACE BETWEEN RECTANGULAR TUBES AND INFILLED CONCRETE AND ITS IMPROVEMENT BY DIAPHRAGM

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Experimental Study on Mechanical Properties of Polypropylene: Steel Fiber Concrete and Loading Characteristics of Shaft Lining

Experimental Study on Damage Breakage Properties of Shaft Lining Concrete under Hydromechanical Coupling

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Mechanical Damage and Failure Behavior of Shaft-Lining Concrete after Exposure to High Pore-Water Pressure

Interface Shear Strength of Liners with Geocomposite

Structural Behavior of Triple-Layer Composite Lining of a Water Conveyance Tunnel: Insight from Full-Scale Loading Tests

Experimental Investigation on Shear Behavior of the Interface between Early-Strength Self-Compacting Shrinkage-Compensating High-Performance Concrete and Ordinary Concrete Substrate

Strength Characteristics of a Smooth HDPE Geomembrane/Nonwoven Geotextile Interface Based on a Novel Ring Shear Apparatus

Experimental investigation on the load-bearing capacity and deformation behaviour of the composite lining with polyurethane compressible layer

Shear Behavior of Silty Clay–Concrete Interface Based on Large-Scale Direct Shear Test

Full-scale experimental investigation on progressive failure characteristics of shield segmental lining connected through segmental joints containing ductile-iron joint panels

Development and Preliminary Application of Temperature Stress Test Machine for Cast-in-Place Inner Shaft Lining

Experimental Study on Shear Transfer Across Interfaces with Post-Installed Shear Reinforcement

Experiment study on shear strength of GM/GCL interface