Abstract:Aging, corrosive environments, and inadequate maintenance may result in performance deterioration of civil infrastructures, and finite element model updating is a commonly employed structural health monitoring procedure in civil engineering to reflect the current situation and to ensure the safety and serviceability of structures. Using the finite element model updating process to obtain the relationship between the structural responses and updating parameters, this paper proposes a method of using the wavelet neural network (WNN) as the surrogate model combined with the wind-driven optimization (WDO) algorithm to update the structural finite element model. The method was applied to finite element model updating of a continuous beam structure of three equal spans to verify its feasibility, the results show that the WNN can reflect the nonlinear relationship between structural responses and the parameters and has an outstanding simulation performance; the WDO has an excellent ability for optimization and can effectively improve the efficiency of model updating. Finally, the method was applied to update a real bridge model, and the results show that the finite element model update based on WDO and WNN is applicable to the updating of a multi-parameter bridge model, which has practical significance in engineering and high efficiency in finite element model updating. The differences between the updated values and measured values are all within the range of 5%, while the maximum difference was reduced from −10.9% to −3.6%. The proposed finite element model updating method is applicable and practical for multi-parameter bridge model updating and has the advantages of high updating efficiency, reliability, and practical significance.

Updating of Concrete Beams Based on Finite Element Model of Static Test

Automated Finite Element Modeling and Analysis of Cracked Reinforced Concrete Beams from Three Dimensional Point Cloud

Experimental Study and Numerical Analysis of A Composite Bridge Structure

INCORPORATING PRE-EXISTING CRACKS IN STRUCTURAL ASSESSMENT OF RC STRUCTURES

Accurate FEM of Steel-Concrete Composite Box Girder Bridge for Damage Identification Based on Dynamical Experimental Study

Bridge load testing and damage evaluation using model updating method

Structural performance assessment of RC flexural members through crack-based fibre beam-column model updating

Simulating analysis of cantilever casting of prestressed concrete bridge

Numerical Method for Creep Analysis of Strengthened Fatigue-Damaged Concrete Beams

Study on Static and Dynamic Behavior of T-Frame Bridge Reinforced by External Tendons

Finite Element Modeling of Concrete Beams Prestressed with External Tendons

Stiffness Degradation Characteristics Destructive Testing and Finite-Element Analysis of Prestressed Concrete T-Beam

Bridge Model Updating Based on Wavelet Neural Network and Wind-Driven Optimization

Finite element method for prestressed concrete plane frame structures

Numerical Analysis for Crack Width of Reinforced Concrete Beam with Bond-Slip Effect

Simulation of cantilever-casting construction of prestressed concrete cable-stayed bridge

Bridge finite element model updating using stochastic vehicle-induced static response monitoring data

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams

Quasi-static Testing and Networked Pseudo-Dynamic Testing on Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Mechanical State Assessment of In-Service Cable-Stayed Bridge Using a Two-Phase Model Updating Technology and Periodic Field Measurements

Finite element model updating method for continuous girder bridges using monitoring responses and traffic videos