Abstract:Significant reductions in the fluid structure interaction regulated transfer of impulse occur when sandwich panels with thin (light) front faces are impulsively loaded in water. A combined experimental and computational simulation approach has been used to investigate this phenomenon during the compression of honeycomb core sandwich panels. Square cell honeycomb panels with a core relative density of 5% have been fabricated from 304 stainless steel. Back supported panels have been dynamically loaded in through thickness compression using an explosive sheet to create a plane wave impulse in water. As the impulse was increased, the ratio of transmitted to incident momentum decreased from the Taylor limit of 2, for impulses that only elastically deformed the core, to a value of 1.5, when the peak incident pressure caused inelastic core crushing. This reduction in transmitted impulse was slightly less than that previously observed in similar experiments with a lower strength pyramidal lattice core and, in both cases, was well above the ratio of 0.35 predicted for an unsupported front face. Core collapse was found to occur by plastic buckling under both quasistatic and dynamic conditions. The buckling occurred first at the stationary side of the core, and, in the dynamic case, was initiated by reflection of a plastic wave at the (rigid) back face sheet-web interface. The transmitted stress through the back face sheet during impulse loading depended upon the velocity of the front face, which was determined by the face sheet thickness, the magnitude of the impulse, and the core strength. When the impulse was sufficient to cause web buckling, the dynamic core strength increased with front face velocity. It rose from about 2 times the quasistatic value at a front face initial velocity of 35 m/s to almost 3 times the quasistatic value for an initial front face velocity of 104 m/s. The simulations indicate that this core hardening arises from inertial stabilization of the webs, which delays the onset of their buckling. The simulations also indicate that the peak pressure transmitted to a support structure from the water can be controlled by varying the core relative density. Pressure mitigation factors of more than an order of magnitude appear feasible using low relative density cores. The study reveals that for light front face sandwich panels the core strength has a large effect upon impulse transfer and the loading history applied to support structures.

Crush Dynamics Of Square Honeycomb Sandwich Cores

A Rate-Independent Constitutive Model for Square Honeycomb Core

Dynamic Compression of Square Honeycomb Structures During Underwater Impulsive Loading

In-plane crushing response and energy absorption of two different arranged circular honeycombs

Constitutive Model For Quasi-Static Deformation Of Metallic Sandwich Cores

Performance of Metallic Honeycomb-Core Sandwich Beams under Shock Loading

Application of Auxetic Core to Improve Dynamic Response of Sandwich Panels Under Low-Velocity Impact

Meta-honeycomb sandwich tubes: Designing, manufacturing, and crashworthiness performance

Mechanical behaviors and failure modes of sandwich cylinders with square honeycomb cores under axial compression

Dynamic response of composite sandwich structures with the honeycomb-foam hybrid core subjected to underwater shock waves: Numerical simulations

Numerical Studies on Failure Mechanisms of All-Composite Sandwich Structure with Honeycomb Core under Compression and Impact Loading Conditions

Metal Sandwich Plates with Polymer Foam-Filled Cores

Crashworthiness and optimization of bionic sandwich cores under out-of-plane compression

Crushing behavior of honeycomb structure: a review

In-Plane Dynamic Cushioning Performance of Concave Hexagonal Honeycomb Cores

Mechanical Behavior and Constitutive Modeling of Metal Cores

Crashworthiness analysis of a novel bioinspired hexagonal honeycomb under out-of-plane crushing

In-plane crushing behavior and energy absorption of CFRP honeycombs with different core topologies

Fabrication, design, and optimization of hierarchical composite Kagome honeycomb sandwich structure under uniaxial compression

Quasi-static Punch Indentation of a Honeycomb Sandwich Plate: Experiments and Modelling

Damage sensitivity studies of composite honeycomb sandwich structures under in-plane compression and 4-point bending: experiments and numerical simulations