Abstract:The bore's circumferential cross-section is not always a perfect circle, due to manufacturing errors, installation, and the influence of high-temperature and high-pressure gas, especially for a cylinder liner of the two-stroke marine diesel engine. This non-axisymmetric feature significantly impacts the lubrication properties of the piston ring and cylinder liner tribo-pair. To study the tribology and lubrication properties of the tribo-pair, a fluidstructure coupled transient mixed lubrication model is developed, which incorporates the piston ring curved beam model and mixed lubrication model. The key challenge lies in integrating the interface contact issue between the piston ring and bore with the structural deformation, requiring a multi-scale modeling strategy. To address this challenge, a method of coupling mesh between the finite difference method and the finite element method (CMFF) is proposed. The approach achieves the requirement for a fine mesh for the interface contact solution while maintaining the accuracy of the curved beam model for the structural response of the piston ring. Based on the model, the lubrication performance and deformation behavior of the piston ring in an elliptical bore are comprehensively analyzed. The results are compared with those of the rigid ring model to explore the overall differences. Results reveal that the current model predicts the friction is mostly caused by asperity contact between solids at the top dead center, whereas the rigid ring model predicts viscous shearing of the lubricant. The discrepancy is mainly due to the reduction of the oil film thickness between the piston ring and the cylinder liner following the consideration of ring deformation. Moreover, the minimum clearance exhibited at the piston ring end gap demonstrates the thorough consideration of the local and global lubrication performance of piston rings in the proposed model. This is significant for the resolution of local friction and wear problems of piston rings in engineering applications. Based on the work, a new framework is established for the study of the coupled performance of piston ring dynamics and tribology.

Research on Hydrodynamic Lubrication of Piston Ring Surface Micro-pores Based on CFD

Numerical Simulation on the Lubrication Performance of Surface Textured Piston Rings

Simulation Analysis on 3D Lubrication Condition for Cylinder Liner-piston Ring

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump

Simulation and Experimental Investigation on Friction Reduction by Partial Laser Surface Texturing on Piston Ring

Analysis Of Tribological Performance Of Piston Ring Lubrication

Analysis of Piston Ring Lubrication with Different Lubricant Supply

Research on the Factors Affecting the Lubrication and Frictional Characteristics of Piston Ring-liner Considering the Heat Conduction between Solid Walls

Influence of Different Surface Texture Parameters on the Contact Performance of Piston Ring-Sleeve Friction Pair of Hydraulic Cylinders

An Improved Lubrication Model Between Piston Rings And Cylinder Liners With Consideration Of Liner Dynamic Deformations

A Numerical Analysis for the Lubrication and Friction Loss of Piston Ring

A Fluid-Structure Coupled Transient Mixed Lubrication Model for Piston Ring Lubrication Property Analysis with CMFF Method

Theoretical Analysis on Hydrodynamic Lubrication of Cylinder Micro-dimple Surface Texture

Effects Of Surface Texturing On The Tribological Behavior Of Piston Rings Under Lubricated Conditions

Three-Dimensional Analysis of Tribological Performance and Heat Transfer in Piston and Cylinder Liner System

Research on the Profile Design of Surface Texture in Piston Ring of Internal Combustion Engine

Numerical and Experimental Analysis of the Honing Texture on the Lubrication Performance of Piston Ring–Cylinder Liner Tribosystem

Numerical Modeling of Lubrication of Piston Ring of Two-Stroke Marine Diesel Engine Considering the Effect of Multi-Scale Grooves on the Cylinder Liner

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

Research on Lubrication Performance of High-speed Heavy-duty Hydrostatic Thrust Bearings

Numerical Study of Influences of Hard Particles in Lubricant on Tribological Performances of the Piston Ring