Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Real Heat Flux Analysis of Continuously Casting Round Billet

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Applying of Real-time Heat Transfer and Solidification Model on the Dynamic Control System of Billet Continuous Casting

The Effect of Mold Structure and Cooling Parameters on Heat Transfer during Billet High-Speed Continuous Casting

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

In-depth study of mold heat transfer for the high speed continuous casting process

Melting and Flowing Behavior of Mold Flux in a Continuous Casting Billet Mold for Ultra-High Speed

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Thickness Distributions of Mold Flux Film and Air Gap in Billet Ultra-High Speed Continuous Casting Mold Through Multiphysics Modeling

Transient flow and mold flux behavior during ultra-high speed continuous casting of billet

Real-Time Heat Transfer Model Based on Variable Non-Uniform Grid for Dynamic Control of Continuous Casting Billets

Numerical Simulation of the Fluid Flow, Heat Transfer, and Solidification in Ultrahigh Speed Continuous Casting Billet Mold

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

Simulation and application of dynamic heat transfer model for improvement of continuous casting process

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Heat transfer behavior in ultrahigh-speed continuous casting mold

Simulation of the Flow-Heat Transfer Process in Billet Mold and Analysis of the Billet Rhomboidity Phenomenon

Investigation on Heat Transfer in Molds with Different Water-Cooling Structures Under Billet High-Speed Continuous Casting

A Three Dimensional Real-time Heat Transfer Model for Continuous Casting Blooms

Analysis of Thermo-fluidic and Phase Change Behaviour of Liquid Steel in a Continuous Billet Caster Mould: Effect of Casting Speed