Abstract:Abstract Selective laser melting (SLM) technology is a rapid prototyping additive manufacturing technology, which is widely used in the biomedical field. Surface texturing technology, as a surface treatment technology, has been used to improve the tribological performance. In the paper, both SLM and surface texturing technology are used to prepare textured samples with different parameters. Under the conditions of dry and phosphate buffer solution (PBS) lubricated conditions, the tribological performance and the mechanism of the textured 316L SS were investigated. The texture parameters studied are characteristic size, area ratio and shape including single triangular, circular and composite textures composed of two shapes. Results show that under dry friction condition, compared with the untextured surfaces, the friction coefficients and wear losses of the three textured samples almost increased, and only the wear loss of the circular textured sample decreases. Under the condition of PBS solution, compared with the untextured surface, most of the friction coefficients and wear loss of the textured samples decreased significantly, but the wear loss of textured surfaces in group B shows an obvious increase. And reducing the characteristic size of the texture significantly increases the wear loss of the 316L SS sample. At the same time, the triangular textured samples have better wear resistance than the circular textured samples. Therefore, the application of surface texturing technology to 316L SS samples prepared by SLM, especially in the simulated body fluid conditions, can achieve the purpose of stable friction and reduce wear loss. Meanwhile, reasonable texture parameters have a greater impact on improving the tribological performance of 316L SS.

Friction and Wear Behavior of 316L Stainless Steel with Laser Micro-Hole Texture and Micro-Square-Column Array Texture

The Study of Micro-grating and Micro-square-column on Frictional Resistance Reduction of 316L Stainless Steel Surface

Friction and Wear Behavior Analysis of the Stainless Steel Surface Fabricated by Laser Texturing Underwater

Laser Surface Texturing of Stainless Steel − Effect of Pulse Duration on Texture's Morphology and Frictional Response

Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear

Effect of Nanosecond Laser Texturization on Tribological Behavior of AISI 321 Stainless Steel

Application of Taguchi Method Design to Investigate Tribological Performance of Laser-Surface-Textured 316L Austenitic Stainless Steel

Tribological Performance of Textured 316L Stainless Steel Prepared By Selective Laser Melting*

Effect Of Pulse Duration On Tribological Behavior Of Textured Stainless Steel By Laser Surface Texturing

Anti-Wear Property of Laser Textured 42CrMo Steel Surface

Effect of multiple laser peening on the wear resistance of 304 stainless steel

Modulation of dry tribological property of stainless steel by femtosecond laser surface texturing

EFFECT OF MICRO-TEXTURES AND CrAlSiN COATINGS ON THE FRICTION AND WEAR PROPERTIES OF 316L STAINLESS STEELS IN SEAWATER

Tribological Properties of Laser Textured Surfaces on 45 Steel under Dry Friction

Laser Melting and Surface Texture Technology: Effect on Friction Properties

Tribological Influence of Laser Surface Textures on 45 Steel under Dry Sliding

Enhanced Wear Resistance Of 316 L Stainless Steel With A Nanostructured Surface Layer Prepared By Ultrasonic Surface Rolling

Friction and Wear Performance of Laser Peen Textured Surface under Starved Lubrication

Effect of Post-Manufacturing Heat Treatment on Wear Performance of Laser Powder Bed Fusion 316L Stainless Steel Under Various Normal Loads

Hydrophobic surface texture air-liquid phase composite assisted laser processing and tribological properties

Fabrication and mechanical measurements of micro- and nano-textured surfaces induced by laser processing