Abstract:Friction stir welding (FSW) tool pin, as a critical component of FSW tool, plays an important role in determining the final joint properties by affecting the heat generation, plastic material flow, welding loads, and so on. However, the effects of tool pin on heat and mass transfer in FSW are not elucidated and quantitative studied. In the present study, a validated model was adopted to quantitatively analyze the effects of pin size and taper angle on the thermal process and plastic material flow in FSW. The effects of pin root diameter, pin tip diameter, and pin taper angle on heat and mass transfer in FSW were quantitatively investigated, respectively. It reveals that the torque and transverse force imposed on the pin are increased with the increase of the pin diameters (including its root diameter, its tip diameter, and its size in condition of constant taper angle), while the total tool torque varies a little for the tool pin diameter considered in this study. When the pin diameters increase, the viscosity of the materials near the pin is decreased, while the temperature as well as the flow velocity is increased. More plastic material near the tool could rotate around the tool with an increase of the pin diameter. The TMAZ boundary is enlarged with larger pin diameters in FSW. Particularly, the shear layer thickness of the same horizontal plane in the range of 1 mm < z < 5 mm is significantly enlarged with an increase of pin root diameters. However, the shear layer thickness of the same horizontal plane in the region of z < 5 mm is increased when using a larger pin tip diameter. In addition, maximum width of TMAZ boundary at the top surface of workpiece was not affected by pin diameters. The model is validated by experimental results. It could lay a solid foundation for optimizing the tool pin size and taper angle in FSW.

The Study of the effect of material mixing on pin injection screw

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Study of screw configuration vs UPVC plastic injection moulding mixing influence

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Mixing and Thermal Transport Behavior in a Pin or Non-Pin Extruder Equipped with a Field Synergy Elongation Screw

Effects of Pin Thread on the In-Process Material Flow Behavior During Friction Stir Welding: A Computational Fluid Dynamics Study

Numerical simulation of metal plastic flow in friction stir welding affected by pin shape

Numerical study of mixing dynamics inside the novel elements of a corotating nontwin screw extruder

Study of Dynamic Flow and Mixing Performances of Tri-Screw Extruders with Finite Element Method

Effects of Screw Reciprocation and Pin Arrangement of Buss Kneader on Mixing Performance

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Study of Performance of Novel Injection Screw

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

3-D Non-isothermal Numerical Simulation of the Effect of Temperature Mixing in Mixing Screw Head of Co-Rotating Twin-screw Extruder

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Analysis of the Dispersive and Distributive Mixing Effect of Screw Elements on the Co-Rotating Twin-Screw Extruder with Particle Tracking

The effect of tool pin size and taper angle on the thermal process and plastic material flow in friction stir welding

The Effect Of Pin Profile On The Mechanical Properties Of Friction Stir Welded Joints Of Ai-Li Alloy

Influence of Pin Geometry on Material Flow in Friction Stir Welding Process

Study on Simulation of Molten Polymer Flow in the Screw Groove