Abstract:Mg-rare earth (RE)-Zn alloys with long-period stacking ordered (LPSO) structure show excellent room temperature, elevated temperature mechanical properties. In this work, microstructure and mechanical properties of Mg-7Gd-5Y-1Nd-2Zn-0.5Zr (wt%) alloy after tensile deformation at various temperatures (room temperature (RT), 250 C-degrees and 300 C-degrees) were investigated. The pre-precipitated alloy exhibited tensile yield strength (TYS) of 149 MPa at room temperature, while it maintained relatively high TYS at 250 C-degrees (154 MPa) and 300 degree celsius (123 MPa). The microstructural characterizations revealed that such outstanding heat resistance is mainly attributed to the blocky LPSO structure near the grain boundary; basal plate-like precipitates, twins and kink bands inside the grain. The blocky LPSO structure exhibits a coherent boundary with one alpha-Mg grain, while being incoherent with other alpha-Mg grains or the LPSO structure. Cracks primarily occured along the incoherent interface. Basal plate-like precipitates formed during elevated temperature tensile deformation included GP zones, gamma', metastable LPSO building blocks, and fine 14H-LPSO structure. A probable gamma-precipitation sequence is supersaturated solid solution -* GP zones (ABAB-type) -* single LPSO building block (gamma')-* various metastable LPSO building block clusters-* 14H-LPSO (gamma). The deformation modes (sliding, twinning, kinking, grain boundary sliding, etc) modified with the tensile temperature increase. dislocations were observed at elevated temperatures. As the temperature of tensile test increases, twins become less. Grain boundary sliding occurs at elevated temperatures.

Thermal-physical Properties of Two Kinds of Mg-Gd-Y-Zr Magnesium Alloys

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Hot Tearing Susceptibility and Solidification Behavior of Mg-xGd-(4-x)Y-2Ni-0.5Zr Alloys

Hot Deformation and Processing Map of As-Homogenized Mg–9Gd–3Y–2Zn–0.5Zr Alloy

Deformation behaviors and the related high-temperature mechanical properties of Mg-11Gd-5Y-2Zn-0.7Zr via regulating extrusion temperatures

Microstructures and Mechanical Properties of the Mg–4.5Zn–xGd (x = 0, 2, 3 and 5) Alloys

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Microstructure, Mechanical and Thermal Properties of Mg-0.5Ca-xZr Alloys

Tuning texture and precipitation using Y/Gd atomic ratio in iso-concentration Mg–Y–Gd–Ag–Zr extruded alloys

Microstructural Evolution and Mechanical Properties of Mg-5y-5gd-Xnd-0.5zr Magnesium Alloys at Different States

Study on Tensile Behavior at Various Temperatures of the Mg-7Gd-5Y-1Nd-2Zn-0.5Zr Alloy

Microstructure of as-cast Mg-4.2Zn-0.8Y (at.%) alloys containing Gd

Study on phase constitutions, growth pattern and mechanical properties of Mg-1.4Gd-1.2Y-xZn-0.15Zr (at%) alloys

Thermal Characteristics of Mg–Zn–Mn Alloys with High Specific Strength and High Thermal Conductivity

Effects of Y content on microstructures and thermal expansion behavior of Mg-Al-Y alloys

Hot compression behavior and microstructure evolution of Mg-Gd-Y-Zn-Zr alloy

Clarifying the deformation modes and strengthening mechanisms of Mg-11Gd-5Y-2Zn-0.7Zr with outstanding high-temperature mechanical properties

Evolutions of Microstructure and Mechanical Properties in Mg–5Li–1Zn–0.5Ag–0.5Zr–xGd Alloy

Microstructure and mechanical properties of cast Mg-6Gd–Zr alloy with different Y addition

Effects of Y, Gd on Microstructure and Mechanical Properties of AZ61 Magnesium Alloy