Abstract:This paper presents the development of a hybrid model for simulating a vertical U-tube geothermal heat exchanger under actual climate.The model consists of a 3D model representing a pair of U-tubes buried in symmetric boreholes and a supplementary 2D model that can be applied to real site scenarios.The temperature series at the wall of the borehole and initial soil temperatures at different depths derived from the simulation results of the 3D model serve as the input boundary conditions of the 2D model.Hence,the hybrid model shares the respective advantages of both subordinate models and therefore provides comprehensive simulation resuhs that span approximately 10 months at a slight cost in implementation complexity.Meanwhile,the model is limited by numerous assumptions such as the consistency between the ground surface and air temperatures and physical uniformity of the materials.Simulations were performed based on the conditions obtained at a real site in the city of Hangzhou.The simulation time range was June 12,2015,to March 17,2016,which covered an entire cooling,transition,and heating season.The collected data revealed that the soil within an effective radius of 2 m gained an absolute increase in internal energy of 0.292 MJ after the simulation.The relative increases in the internal energy and average temperature were 1.037 MJ and 0.28 K,respectively,compared to those affected only by climate,which indicated an unwanted accumulation of heat beneath the ground.Moreover,the temperature at a deeper soil depth showed a lag in phase behind that of a shallower depth.This lag was approximately 2 weeks between a point at the center of the entrance and exit of the U-tubes and a point 1 m below it.Moreover,the fluctuation patterns of the inlet/outlet fluid temperatures showed a significant shift from the air temperature toward the annual averages,which were-8.313 K in the cooling season and 9.077 K in the heating season.Finally,the temperature distribution among pipe-clusters at different depths showed that the heat accumulation mainly occurred at a depth greater than 7 m,and the accumulation was more severe at a shallower depth and at the corners of clusters.

Three-dimensional numerical simulation and heat transfer analysis for U-tube ground heat exchangers

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Numerical simulation of soil temperature field surrounding vertical U tube heat exchanger for ground coupled heat pump

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger

A Simplified Semi-Numerical Model to Simulate a U-pipe Ground Heat Exchanger

Finite Element Analysis for the Heat Transfer of Ground Heat Exchanger

A novel numerical model considering unsaturated soil properties and computational study on heat and moisture transfer characteristics of helix ground heat exchanger

Numerical simulation and thermal analysis of ecological energy-saving ground source heat pump design

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Numerical Simulation and Analysis of Performance of Fin-and-tube Heat Exchanger with Complex Circuit Arrangement

THREE-DIMENSIONAL NUMERICAL SIMULATION OF TURBULENT FLOW AND HEAT TRANSFER CHARACTERISTICS IN SHELL SIDE OF SHELL-AND -TUBE HEAT EXCHANGERS

NUMERICAL SIMULATION OF LAMINAR FLOW AND HEAT TRANSFER IN SHELL-AND-TUBE HEAT EXCHANGER WITH HELICAL BAFFLES

Hybrid 3D and 2D Numerical Models of Geothermal Heat Exchanger for Ground Source Heat Pump System

NUMERICAL ANALYSIS OF AN AIR - COOLED PLAIN - FINNED TUBE HEAT EXCHANGER

3D Numerical Simulation on Fluid Flow and Heat Transfer Characteristics in Multistage Heat Exchanger with Slit Fins

Simulation study on cooling potential of multi-tube earth-air tunnels

Two-Dimensional Numerical Method For Thermaland Hydraulic Design Of Multistreamplate-Fin Heat Exchanger

Prediction and Parametric Analysis of 3D Borehole and Total Internal Thermal Resistance of Single U-tube Borehole Heat Exchanger for Ground Source Heat Pumps

Comparative analysis of heat transfer performance of the smooth U-tube and finned U-tube in ground source heat pump

Numerical Estimation of Heat Transfer Characteristics for Two-Row Plate-Finned Tube Heat Exchangers with Experimental Data

NUMERICAL SIMULATION AND ANALYSIS OF UNDERGROUND DUCT SYSTEM