Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Thermoelectric properties of AgSbO3 with defect pyrochlore structure

Microstructure and Thermoelectric Properties of AgSbO 3 Ceramics Prepared by Ion-Exchange Powder Synthesis and Normal Sintering

Synthesis and Transport Properties of Agbi3s5 Ternary Sulfide Compound

Phase compositions, nanoscale microstructures and thermoelectric properties in Ag2-ySbyTe1+y alloys with precipitated Sb2Te3 plates

Point defect approach to enhance the thermoelectric performance of Zintl-phase BaAgSb

Elaborating the Crystal Structures of Mgagsb Thermoelectric Compound: Polymorphs and Atomic Disorders

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

Thermoelectric Properties of the Cubic AgPb10SbTe12

Modulated Fermi Level and Relaxed Lattice Strain Leading to Enhanced Thermoelectric Properties in AgSbSe 2

Effects of Sb Deviation from Its Stoichiometric Ratio on the Micro- and Electronic Structures and Thermoelectric Properties of Cu12Sb4S13.

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Decreased order-disorder transition temperature and enhanced phonon scattering in Ag-alloyed Cu3SbSe3

Thermoelectric properties of polycrystalline tetragonal SrCu2O2

Microstructure and Thermoelectric Properties of Cubic AgPb18Sb1−xTe20 (x = 0.1, 0.3, 0.5) Compounds

Promising Zintl-Phase Thermoelectric Compound SrAgSb

Enhancing Thermoelectric Performance of AgSbTe 2 -Based Compounds via Microstructure Modulation Combining with Entropy Engineering

Defect Chemistry, Phase Transitions, and Thermoelectric Properties of Ca1–xCexAg1–ySb (0 ≤ X ≤ 1; 0 ≤ Y ≤ 1)

[O47] Phase equilibria of thermoelectric materials: Ag-Sb-Te and AgSbTe2-AgSbSe2

High-Temperature Thermoelectric Properties And X-Ray Photoemission Spectra Of Layered Co-Based Oxides Bi2-Xagxsr2co2o8-Delta

High Thermoelectric Performance in the New Cubic Semiconductor AgSnSbSe 3 by High-Entropy Engineering

Thermoelectric Properties of Ag-doped N-Type (bi2te3)0.9–(bi2−xagxse3)0.1 (x=0–0.4) Alloys Prepared by Spark Plasma Sintering