Abstract:In the process of gas drilling, the cuttings transported by the fluid flow through the natural gas gathering pipeline at high speed, resulting in serious erosion damage to the pipeline, thus endangering the safety of the drilling process. This study attempts to research the erosion wear law of AISI 1020 steel under the effects of solid particles. The model particle was extracted according to the shape characteristics of the cuttings, and the dynamic behavior of the cuttings was simulated by FEM. The characteristics of the impact stress on the surface of AISI 1020 steel and the accumulation form of erosion pits were analyzed under different impact angles, velocities, and particle sizes. Under the given calculation parameters, with an increase in the impact angle, the maximum equivalent stress of the target first increased, then decreased, and reached a maximum value of 1360 MPa, at an impact angle of 45°. At a large impact angle, the erosion pit was characterized by gouging and plastic extrusion. At a small impact angle, the erosion pit mainly comprised micro-cutting and furrow lips. There was material accumulation on both sides and the front end of the erosion pit, and the height of the deformation lip at the front end of the erosion pit increased gradually. With an increase in the impact velocity of the cuttings, the maximum equivalent stress, the accumulation material at the front end of the erosion pit, and the height of the deformation lip increased significantly. When the particle size was less than 0.15 mm, the maximum equivalent stress increased with the increase in particle size, and reached the maximum value of 1410 MPa at 0.15 mm. When the particle size exceeded 0.15 mm, the maximum equivalent stress decreased with the increase in particle size. The dynamic behavior of rock cuttings impacting AISI 1020 steel was successfully simulated by the finite element method. The influences of the impact angle, impact velocity, and particle size on the impact process of AISI 1020 steel was determined.

Erosion and abrasion on mild carbon steel surface by steam containing SiC microparticles

Water Erosion Mechanism of Mild Carbon Steels Induced by Micro-Particles

Investigation of Erosion Damages Induced by Wet Steam Containing Micro-Particles

Effect of Microparticle Properties on Erosion in Solid-Steam Mixtures

Experimental study on erosion wear behavior of PFA coated stainless steel tube

Damages on Steel Surface at the Incubation Stage of the Vibration Cavitation Erosion in Water

On Mechanism of Cavitation Erosion of Rough Surface

Experimental and numerical investigations on development of cavitation erosion pits on solid surface

Effect of micro-particles on cavitation erosion behavior of 2Cr3WMoV steel

Experimental Study of Cavitation Erosion Damage Affected by Microparticles

Affected Zone Generated Around the Erosion Pit on Carbon Steel Surface at the Incipient Stage of Vibration Cavitation

An Experimental Study on Cavitation Erosion-Corrosion Performance of ANSI 1020 and ANSI 4135 Steel

The Difference Between Synergistic Erosion–corrosion and Corrosion of Mild Steel in SiC Suspension

Inhibition of the Ultrasonic Microjet-Pits on the Carbon Steel in the Particles-Water Mixtures

Interface Shear Behavior Between MICP-Treated Calcareous Sand and Steel

Experimental Study and Analysis on Incipient Stage of Cavitation Erosion

Experimental and Numerical Simulation Study on Erosion Wear Behavior of AISI 1020 Steel

Experimental system of cavitation erosion with water-jet

Errosion-Corrosion Critical Performance of Surface Nanocrystalline 20 Carbon Steel in Condensate Water

Slurry and liquid impingement erosion behavior of low-temperature plasma carburized AISI 420 martensitic stainless steel

Surface Ripple and Erosion Rate of Stainless Steel under Elevated Temperature Erosion by Angular Solid Particles