Abstract:The measurement of Na+, K+ and H+ is essential in medicine and plays an important role in the assessment of tissue ischemia. Microfabrication, inkjet- and screen-printing can be used for solid contact ion selective electrodes (ISE) realization; these, however, can be non-standardized, costly and time consuming processes. We present the realization of ISEs on post-processed electrodes fabricated via standardized printed circuit board (PCB) manufacturing techniques. In vitro results are presented from two rigid platforms (32 ISEs) for liquid sample dip-stick measurements and two flexible platforms (6 and 32 ISEs) for post-surgical intestinal tissue monitoring, each with a common reference electrode (RE). These are combined with optimized tetrapolar bioimpedance sensors for tissue ischemia detection. Both electroless and hard gold PCB finishes are examined. Apart from the electroless rigid platform, the rest demonstrated comparable and superior performance, with the pH sensors demonstrating the greatest deviation; the flexible hard gold platform achieved a sensitivity 4.6mV/pH and 49.2mV/pH greater than the electroless flexible and rigid platforms, respectively. The best overall performance was achieved with the hard gold flexible platform with sensitivities as large as 73.4mV/pH, 56.3mV/log [Na+], and 57.4mV/log [K+] vs. custom REs on the same substrate. Simultaneous measurement of target analytes is demonstrated with test solutions and saliva samples. The results demonstrate superior performance to other PCB-based pH sensors and Na+ and K+ PCB-based sensors with comparable performance to potentiometric sensors fabricated with other techniques, paving the way towards mass-produced, low-cost, disposable, multi-parametric chemical sensing diagnostic platforms.

Electrical Properties of Polysilicon Electrodes for Conductometric Measurement

A Miniature All-Solid-State Calcium Electrode Applied to in Situ Seawater Measurement

An All-Solid-State Silicate Ion-Selective Electrode Using PbSiO3 As a Sensitive Membrane

All-solid-state Potentiometric Sensor Using Single-Walled Carbon Nanohorns As Transducer

Fabrication and Characterization of Potassium Ion-Selective Electrode Based on Porous Silicon

Understanding the electrolyte background for biochemical sensing with ion-sensitive field-effect transistors.

Porous silicon-based potassium ion selective electrode

Characterization and Application of a Metallic Tungsten Electrode for Potentiometric Ph Measurements

Impedance spectroscopy of polysilicon in SOI structures

Construction of all-solid-state ion-selective sensors using electrolyte-containing polymers

The Influence of the Conditioning Procedure on Potentiometric Characteristics of Solid Contact Calcium-Selective Electrodes in Nanomolar Concentration Solutions

A Mott-Schottky analysis of mesoporous silicon in aqueous electrolyte solution by electrochemical impedance spectroscopy

Multi-parametric Rigid and Flexible, Low-Cost, Disposable Sensing Platforms for Biomedical Applications.

A Direct-Reading MEMS Conductivity Sensor with a Parallel-Symmetric Four-Electrode Configuration

Optimization of an electrolyte conductivity detector for measuring low ion concentrations

An all-solid-state screen-printed carbon paste reference electrode based on poly(3,4-ethylenedioxythiophene) as solid contact transducer

Batch Fabrication of Miniaturized Ag/AgCl Reference Electrode with Ion Exchanging Micro-Nano-Pores by Silicon-Base Double-Side Anisotropic Etching Process

A Mott-Schottky Analysis of Mesoporous Silicon in Aqueous Electrolyte by Electrochemical Impedance Spectroscopy

Optimization of Electrolytes with Redox Reagents to Improve the Impedimetric Signal for Use with a Low-Cost Analyzer

A Biodegradable Porous Silicon and Polymeric Hybrid Probe for Electrical Neural Signal Recording

A Coil-Coupled Sensor for Electrolyte Solution Conductivity Measurement