Abstract:The high-speed serial transceiver plays a key role in the high-speed data transmission. Because of the independent clock network in each transceiver, there exist random skews between the multiple transceivers each time the system reinitializes. In the system of data transmission, these random skews are always permitted and the intrachannel synchronization is guaranteed by inserting some same comma codes in each channel. However, for the strict clock distribution system, these random skews are unacceptable. To address this problem, a scheme combined of a tunable phase interpolator (PI) and a high-precision time-to-digital converter (TDC) is presented. A plain TDC is employed to measure the skews of parallel clocks in multichannels with bin size of similar to 10.2 ps and precision of similar to 18.0 ps. The method of multiple measurements average is adopted to further improve the TDCs performance. On this basis, time synchronization with root mean square (rms) of similar to 2.5 ps and peak-to-peak value of similar to 14.7 ps is implemented in a 20-nm fabrication process ultrascale field programmable gate array (FPGA). Compared to the measured results (rms of similar to 22 ps and peak-to-peak value of similar to 105 ps) of the Xilinx self-phase alignment method, the presented scheme has more than six times performance improvement. In addition, this scheme can lock the delay between different channels to arbitrary configurable offsets, making it very suitable for scenarios where multichannel latencies are strictly restricted.

Method of Clock Phase Correction in Wide-band Data Acquisition Based on FPGA

Real-time Phase Difference Measurement Method with FPGA Speeding Up

A Clock and Data Recovery Method Based on Phase Detector Implemented by Delay Chain in FPGA

FPGA Based Frequency Correction of Master Clock Terminals of Whole-View Test Systems

A simple method for precise phase alignment between high-speed transceivers in FPGA

A Proof-of-Concept FPGA-Based Clock Signal Phase Alignment System

Design of Multifunction Digital Clock Based on FPGA

A New Clock Phase Calibration Method in High-Speed and High-Resolution DACs

Implementation of an Intelligent Digital Phase-Locked Loop Based on FPGA

Design of DPLL for Bit Synchronous Clock Based on FPGA

Correction of optical clock noises in high-speed optical analog-to-digital conversion system based on phase-encoded method

Phase Spectrum Algorithm for Correction of Time Distortion in A Wavelength Demultiplexing Analog-To-Digital Converter

Frequency correction of master clock terminal for whole-view test system based on FPGA

Two Novel Designs Of Multi-Phase Clocked Ultra-High Speed Time Counter On Fpga For Tdc Implementation

Design and Implementation of Integral DPLL Based on FPGA

Sigma-delta based clock recovery using on-chip PLL in FPGA

The Implementation of IEEE 1588 Clock Synchronization Protocol Based on FPGA.

A High-Precision 2.5-Ps RMS Time Synchronization for Multiple High-Speed Transceivers in FPGA

Real-Time Phase Correction Based on FPGA in the Beam Position and Phase Measurement System

Control of field flatness based on FPGA for multi-cell cavity

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization