Abstract:BackgroundThe superconducting third harmonic cavity has been developed independently in Shanghai Synchrotron Radiation Facility (SSRF) and passed beam tests. The cavity electric field needs to be precisely controlled during operation to achieve the goal of stretching beam cluster and improving beam life.PurposeThis study aims to design a digital low level radio frequency (DLLRF) controller for superconducting third harmonic cavity at SSRF.MethodsThe hardware of controller was based on a field-programmable gate array (FPGA) board and a front-end board whilst in-phase/quadrature (I/Q) demodulation techniques were implemented in the software of controller. A synergistic strategy was adopted for driving the stepper motor with slow tuning speed and piezoelectric ceramic with fast tuning speed, and an algorithm for the quench detection for passive cavity. Finally, experimental tests were performed to verify the effectiveness of this designed DLLRF.ResultsWhen the state is in top-up mode over 120 mA, the amplitude stability has improved form ±5% with open loop to less than ±1% with close loop, the voltage of piezo has varies smoothly and stably within 120 V, and the beam life has improved more than doubled.ConclusionA digital low level radio frequency controller for the superconducting third harmonic cavity has been designed and satisfies the requirements for SSRF.

Control of field flatness based on FPGA for multi-cell cavity

Digital phase control system for ssrf linac

Design Of A Low Power Wide-Band High Resolution Programmable Frequency Divider

Design of rf front end for cavity beam position monitor based on ics *

Design of LED Production Equipment Molding Motion Controller Base on FPGA

Digital LLRF Controller for SSRF Booster RF System Upgrade

Low level radio frequency controller for superconducting third harmonic cavity at SSRF

An Improved Line - Drawing Algorithm for Arbitrary Fractional Frequency Divider / Multiplier Based on FPGA

Single Field HIE FDTD Solver with Nonuniform Grid Stratagem for More Fine Structure

Realization of Arbitrary Ratio Frequency Division Electronic Gear

A low-delay reference tracking algorithm for microwave measurement and control

A Programmable Divider with Extended Division Range for 24ghz FMCW Frequency Synthesizer

Design of a Low Level Radio Frequency Control System for the Direct Current-Superconductive Photocathode Injector at Peking University

FPGA Integer Frequency Divider Design and Simulation based on Verilog

An Electronic Controller Based on FPGA for the Ramsey-CPT Atomic Clock

Design of Driving and Temperature Control Circuitry for VCSEL

Design and Implementation of Efficient FFT Processor for Multicarrier System

The Realization of Division and Multichannel Output of High-Frequency Clock Using the FPGA

Efficient Prototyping of a Field-Programmable Gate Array-Based Real-Time Model of a Modular Multilevel Converter

Simulation and Improvement of 5ghz Power Divider on FR-4 PCB

Limit Values Acquisition In Field Control Problems Using Information Based Time Reversal Technique