Abstract:Rietveld refinement was utilized to investigate the evolution of microstructure and texture of the Ni-Ti composite coatings electroplated at different applied current densities. Scanning Electron Microscope and Energy Dispersive Spectroscopy were utilized to investigate the morphology and chemical composition of the coatings. Relative texture coefficients (RTC) and measured pole figures were utilized to investigate the texture evolution of the coatings. The results showed that the surface morphology of the coatings changed from a colonial structure to a polyhedral one. And the incorporated Ti content decreased with increasing applied current density. As the applied current density increased, the crystallite sizes increased and their distribution got less uniform, and the microstrain and dislocation density decreased. The results of simulated pole figures obtained from Rietveld refinement illustrated that the texture of the coatings changed from no obvious texture to a strong [2 0 0] fiber texture with increasing applied current density. The texture evolution obtained from simulated pole figures was confirmed by the result of RTC and the measured pole figures. The evolutions of the microstructure and texture were derived from the change of the applied current density and incorporated Ti content in the Ni-Ti composite coatings. (C) 2015 Elsevier B.V. All rights reserved.

Application of XRD ω-scan Technique in Determining the Texture of Ni-Fe Alloy Coatings

Effect of Annealing Treatment on the Texture and Stress of Ni-Fe Alloy Coating

The measurement approach of X-ray residual stress in Fe-Ni alloy with different textures

X-ray diffraction characterization of electrodeposited Ni–Al composite coatings prepared at different current densities

Quantitative Analysis of a Textured Coating by a New X-Ray Diffraction Method

Preparation and Properties of Textured Ni–W Coatings Electrodeposited on the Steel Surface from a Pyrophosphate Bath

Preparation of Al-Cr-Fe Coatings by Heat Treatment of Electrodeposited Cr/Al Composite Coatings

A Preliminary Investigation for Application of an Advanced X-Ray Diffraction Analyzer to In-Process Texture Assessment of Aluminum Alloy Sheet

Influence of Cr on the Surface Properties of the Micro-Textured WC+Co Alloy Coating

Study on Microstructure and Thermal Fatigue of FeMnCrAl/WC Coatings

Application of grazing incidence wide-angle X-ray scattering to characterise mechanically plated coatings

XRD ANALYSIS OF NANOSTRUCTURES IN FeAl BASED COATINGS PREPARED BY THERMAL SPRAYING

Investigation on the evolution of microstructure and texture of electroplated Ni–Ti composite coating by Rietveld method

Fabrication and Characterization of Ni–Zr Composite Coatings Using Electrodepositing Technique

CHARACTERISTIC OF INTERNAL STRESS AND TEXTURE IN ELECTROPLATED COPPER THIN FILMS

The Electrodeposition of Ni-Fe-Cr Alloy Coatings on Mild Steel Surfaces and Evaluation of Corrosion Resistance

Study on Microstructure and Properties of FeNiCr/Ni Coated Cr_3C_2 Coatings Deposited by High Velocity Arc Spraying

Application of Small- and Ultra-Small-Angle Neutron Scattering for the Characterization of Mechanically Plated Coatings

Electrochemical Deposition and Corrosion Resistance Characterization of FeCoNiCr High-Entropy Alloy Coatings

Characterization of Ni-Based Alloy Coating by Thermal Spraying Process

Study on Structure and Properties of Electrodeposited Co-Ni Alloy Deposits