Abstract:Hot rolling of steels represents one of the most critical steps to achieve finished products with high surface quality. The increasing productivity added to the rising customer requirements result in more and more severe scheduling rules for the HSM. Strip surface aspect is very important in terms of HSM operation costs and productivity limitation. Among all surface defects, the most crippling comes from the oxide scale formed at the surface of the steel during the hot rolling, at the entry of the finishing mill (last part of the hot strip mill): the secondary scale, mechanical behaviour of which is still poorly known. The secondary scale may fracture under the stresses imposed by the successive rolling passes, and can be embedded in the steel strip surface: this defect is called "rolled-in scale defect". In addition, the extrusion of the subjacent metal inside the oxide cracks induces large local modifications of friction and heat transfer conditions. Consequently, a precise description of oxide scale deformation mechanisms is necessary to better define the boundary conditions in a roll bite and to better understand the initiation mechanisms of rolled-in scale defects. Our scientific objective is then to provide a realistic physical and numerical model to simulate the oxide scale flow in the roll bite and in particular, its damage. After the presentation of the industrial process and the context of this study, the physical and mechanical properties of the oxide scale in the finishing mill are investigated. We introduce the Forge2® finite element software, selected for this study to simulate the oxide scale behaviour in a finishing mill stand. The numerical developments performed to simulate the different kinds of oxide damage are described. Three mechanical tests have been selected to approach the solicitations undergone by the oxide scale at the entry of the roll gap, suspected to be critical for damage: the 4-point hot bending test, the hot tension test and the hot plane strain compression test. A numerical study is performed in parallel. Based on constitutive data obtained from these three mechanical tests, the mechanical description of a rolling stand is sufficient for satisfactory simulation of the industrial process.

Surface Oxide Fracture in Cold Aluminium Rolling

Micro Crack of Aluminum Sheet During Cold Rolling

Surface Generation and Boundary Lubrication in Bulk Forming of Aluminium Alloy

Analysis of surface roughness of cold-rolled aluminium foil

Fracture Behaviour of Aluminium Alloy Sheet under Roller Hemming Process

Predicted Fracture Tendency of Naturally Occurring Aluminum Surface Coatings under Tensile Loading

Tensile Fracture of Ultrafine Grained Aluminum 6061 Sheets by Asymmetric Cryorolling for Microforming

Formation and structure of a subsurface layer in hot rolled aluminium alloy AA3104 transfer bar

Measurements of Surface Roughness in Cold Metal Rolling in the Mixed Lubrication Regime

The effect of oxide scale of stainless steels on friction and surface roughness in hot rolling

The Effect of Cold Rolling on the Corrosion Behaviour of 5083 Aluminium Alloys

Study on Rolling Defects of Al-Mg Alloys with High Mg Content in Normal Rolling and Cross-Rolling Processes

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Microstructure and mechanical properties of high-temperature free-oxygen rolled Cu/1060Al bimetallic composite materials

Effects of surface preparation on tribological behaviour of a ferritic stainless steel in hot rolling

Experimental study and numerical simulation of iron oxide scales mechanical behavior in hot rolling

Fabrication of Ultrathin Al Foils by Accumulative Pack Rolling: Influence of Pack Materials

Unveiling the Underlying Mechanism of Forming Edge Cracks Upon High Strain-Rate Rolling of Magnesium Alloy

Microstructural Evolution and Mechanical Properties of Pure Aluminum upon Multi-Pass Caliber Rolling

Oxide scale characterization of ferritic stainless steel and its deformation and friction in hot rolling

Investigation of the mechanisms on the abnormal features observed in thermal-mechanical testing of AA6061 under extrusion conditions