Abstract:The crystal structure, phase abundance, microstructure and electrochemical properties of the AB(2)-type Laves phase hydrogen storage alloy Zr0.7Ti0.3Mn0.4V0.4Ni1.2 were studied, prepared both by arc-melting and melt-spinning. The XRD patterns have revealed that two Laves phases, C14 and C15 are formed in the as-cast alloy. In the melt-spun alloy, besides the C14 and C15 phase in very fine crystal grains, there appears a new crystalline C14 phase with very fine crystallites, which is named the nanocrystallite C14 in this paper. SEM and EDS analyses have indicated that the microstructure of melt-spun alloy is a very fine dendritic structure (10 x 3 mum), while the as-cast alloy is a much coarser dendritic structure (300 x 50 mum) with noticeable composition segregation. Electrochemical tests have indicated that the melt-spun alloy has a higher discharge capacity of 385 mA h g(-1) in comparison with 371 mA h g(-1) for the as-cast alloy and the melt-spun alloy has very good cycling stability. After 500 cycles, 80.7% of the initial discharge capacity is retained, much higher than 63.1% of the as-east alloy. It is thus inferred that the electrochemical capacity of the nanocrystallite C14 phase is higher than that of the conventional C14 phase. Nevertheless, the activation property and the high-rate dischargeability of the melt-spun alloy were both found to decrease noticeably, most probably due to the higher resistance against decrepitation and cracking of the alloy with a more refined grain structure. (C) 2002 Elsevier Science B.V. All rights reserved.

Investigations on ML(NiCoMnTi)5 Alloys Prepared with Different Solidification Rates

The Effect of Solidification Rate on the Microstructure and Electrochemical Properties of Co-free Ml(NiMnAlFe)5 Alloys

Influence of the material processing on the electrochemical properties of cobalt-free Ml(NiMnAlFe)5 alloy

Microstructure and electrochemical properties of rapidly solidified alloy Ml(NiCoMnTi)5

Preparation and electrochemical properties of unidirectionally solidified Ml(NiCoMnTi)5 alloys

Characterization of MmNi3.6Co0.75Mn0.55Al0.1 Alloys Prepared by Casting and Quenching Techniques

Electrode Characteristics of Non-Stoichiometric Ml(Nimnalfe)(X) Alloys

Influence of Annealing Treatment on Microstructure and Cycling Stability of La-Rich Ml(Nicomnal)(5) Alloy Electrode for Ni/Mh Batteries

Characterization of MmNi36Co0.75Mn0.55Al0.1 alloys prepared by casting and quenching techniques

Effect of solidification rate on the phase structure and electrochemical properties of alloy Zr0.7Ti0.3(MnVNi)2

The Effects of Titanium on the Phase Structure and Charge/Discharge Performance of Ml(Nicomnti)(5) Alloy

Phase Structures And Hydrogen Storage Capabilities Of The Alloys (Ml)(X) (Ni3.8co0.75mn0.4ti0.05)

Effect of Rapid Solidification Process on the Alloy Structure and Electrode Performance of Zr(Ni0.55V0.1Mn0.3Cr0.55)2.1

Microstructure and Electrochemical Characteristics of Melt-Spinning Alloy Ml( NiCoMnAl)5

Microstructure and electrochemical behaviors of melt-spinning alloy Ml(NiCoMnAl)5

Electrochemical properties and Rietveld analysis of Multicomponent MlβMm1-β (NiCoMnTi)5 hydrogen storage alloys (2) Rietveld analysis

The phase structure and electrochemical properties of the melt-spun alloy Zr0.7Ti0.3Mn0.4V0.4Ni1.2

Phase structures of RENi4.3-xCoxMn0.4Al0.3 (x=0.5 similar to 1.3)hydrogen storage alloys and their electrochemical performance at high temperature

An electrochemical investigation of mechanical alloying of MgNi-based hydrogen storage alloys

The Effects of Partial Substitution of Mn by Cr on the Electrochemical Cycle Life of Ti-Zr-V-Mn-Ni Alloy Electrodes of a Ni/MH Battery

The Effects of Partial Substitution of Mn by Cr on the Phase Structure, Microstructure and Electrochemical Properties of Ti-Zr-V-Mn-Ni Hydrogen Storage Alloys