Abstract:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, Ahead of Print. Due to the high speed and high pressure operating conditions, wear between the finger seal and the rotor is inevitable, and this leads to an increase of leakage clearance and becomes an important factor affecting the seal life. The theory of anisotropic elasticity was employed to describe the mechanical characteristics of the seal material. An improved Archard wear model was proposed to calculate the nodal wear rate, and the local wear direction was also determined. The wear simulation model and procedure were established based on the Arbitrary Lagrangian Eulerian adaptive mesh strategy. The effects of material density, fabric orientation, pressure differential and rotor speed on the wear characteristics of finger seal and the change of leakage clearance caused by wear loss were studied. The results show that the wear first occurs at the heel area of the finger foot bottom and gradually extends to the toe area. C/C (carbon fibre reinforced carbon matrix) composite finger seal with higher material density has smaller leakage clearance and wear depth. With the increase of fabric orientation angle, the wear depth in the heel area of finger foot is smaller, and the circumferential wear area is narrower. The average wear depth of finger seal decreases with the orientation angle. When the orientation angle is 0, the seal leakage clearance is smaller. The increase of pressure differential not only aggravates the seal wear, but also expands the wear area, and also increases the average contact pressure and leakage clearance. Increasing the rotor speed make the wear depth of the heel area of finger foot gradually increase, but the wear area becomes narrower. The average contact pressure decreases and the average leakage clearance increases. This study provides a theoretical method and basis for the prediction and evaluation of the wear life and performance of C/C composite finger seal.

Influence of surface state on the mechanicalseal properties of the resin impregnated graphite composites

Tribological Properties of Seals in Integrated Transmission of Vehicle

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Comparative study on fretting friction and wear characteristics of different impregnated graphite for sealing application

Study on the lubrication film formation and characteristics of different graphite seal composites

Evaluation on frictional performance of three different oil-lubricated impregnated graphite seal rings for aircraft integrated drive generators

Effect of graphite and its surface modification on thermal conductivity of silicone rubber

Experimental investigation on frictional behavior and sealing performance of different composites for seal application

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

Frictional performance of silicon carbide under different lubrication conditions

Experimental investigation of the effect of typical surface texture patterns on mechanical seal performance

Mechanical Properties of Agraphite Gasket Sealing Interface

Application Of Ag/Graphite Seal Rings In Heat Extraction Of Oil

Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

Frictional performance of surface-textured phenolic resin-impregnated graphite materials under water lubrication

Friction Characteristics of Impregnated and Non-Impregnated Graphite Against Cemented Carbide under Water Lubrication

Wear modelling and sealing performance prediction of C/C composite finger seal

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump

Tribological Characteristic of a Ring Seal with Graphite Filler

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Friction and wear performances of impregnated graphite in ring-on-ring tribological test