Abstract:A series of K-ZrO2/Cu/Al2O3 catalysts (KZC(T)A (T= 600-900 degrees C)) were prepared by a sequential impregnation method and investigated for the direct synthesis of ethanol and isobutanol from syngas. The calcination temperature for C(T)A (T= 600-900 degrees C) preparation had considerable effect on the structure and catalytic performance of KZCTA catalysts. By increasing the calcination temperature from 600 to 900 degrees C, the CO conversion was promoted obviously from 20.3 to 53.0%. When the calcination temperature was lower, KZC(700)A catalyst showed high isobutanol selectivity of 17.7 wt%, while only a small amount of isobutanol was obtained in the reference catalysts of KZA and KC(700)A without Cu or Zr as promoters. The coexistence of Cu and Zr in the catalyst was required for isobutanol formation. Furthermore, the Cu-ZrO2 interface amounts increased firstly with the increase of calcination temperature and then decreased at over-higher calcination temperature because of the aggregation of ZrO2. The isobutanol selectivity changed with the Cu-ZrO2 interface amounts in catalyst, suggesting that the Cu-ZrO2 interfaces were responsible for isobutanol preferable synthesis directly from syngas. In addition, ethanol selectivity increased clearly up to 36.3 wt% when the higher calcination temperature 900 degrees C was employed for catalyst preparation. In comparison with the KZC(900)A catalyst, the catalyst of KC(900)A prepared without Zr as promoter exhibited excellent catalytic performance for the ethanol synthesis (33.5 wt%). It revealed that Zr cannot contribute to ethanol formation, and the newly formed CuAlO2 phase under higher calcination temperature in the catalysts possibly favored ethanol formation. As confirmed by XRD, Raman spectroscopy and H-2-TPR, the CuAlO2 phase emerged and its amount increased with the increase of calcination temperature for catalyst preparation. A good linear relationship was found between ethanol selectivity and the amount of CuAlO2, proving that the CuAlO2 phase acted as efficient active sites for ethanol preferable synthesis directly from syngas.

Effect of Calcination Temperature on the Structure and Catalytic Performance of K2wo4/Al2o3 Catalysts for Methanethiol Synthesis

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Influence of the Calcination on the Activity and Stability of the Cu/ZnO/Al2O3 Catalyst in Liquid Phase Methanol Synthesis

The effect of calcination time on the activity of WO3/Al2O3/HY catalysts for the metathesis reaction between ethene and 2-butene

Effect of Calcination Temperature of the Support and the Catalyst of Wo3/Sno2 on the Catalytic Oxidation of 1,2-Benzenedimethanol by H2o2

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Influence of Calcination Temperature on the Stability of Fluorinated Nanosized HZSM-5 in the Methylation of Biphenyl

Effects of Calcination Temperature on Structure-Activity of K-ZrO2/Cu/Al2O3 Catalysts for Ethanol and Isobutanol Synthesis from CO Hydrogenation

Effects of Calcination Temperature on the Catalytic Performance of Ni-Al2 O3 Catalyst

Dynamic Transformation of Active Components in Cu-ZnO-Al_2O_3 Catalyst for Methanol Synthesis at High Temperature

Effect of Calcination Temperature on Crystal Structure and Photocatalytic Prop- Erty of TiO2/Diatomite Nanoparticles

Effect of Calcination Temperature of Monodispersed Sio2 on the Performance of Rh-Based Catalysts for Co Hydrogenation

A gel-oxalate co-precipitation process for preparation of Cu/ZnO/Al2O3 ultrafine catalyst for methanol synthesis from CO2+H2: (II) effect of various calcination conditions

EFFECT OF CALCINATION TEMPERATURE ON THE STRUCTURE AND CATALYTIC PERFORMANCE OF THE CU-MCM-41 CATALYSTS FOR THE SYNTHESIS OF DIMETHYL CARBONATE

Influence of Carbonization Conditions on Structural and Surface Properties of K-Doped Mo2C Catalysts for the Synthesis of Methyl Mercaptan from CO/H2/H2S

Effect of Calcination Temperature on Structure and Properties of Sn–Nb 2 O 5 /Α-Al 2 O 3 Catalyst for Ethylene Oxide Hydration

The effect of synthesis parameters on ordered mesoporous nickel alumina catalyst for CO2 methanation

Effects of Calcinations Temperature on the Properties of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Synthesis of C-2 Oxygenates from Syngas over Monodispersed Sio2 Supported Rh-Based Catalysts: Effect of Calcination Temperature of Sio2

Effect of Calcination Temperature on Structure and Catalytic Performance of Nb2O5/α-Al2O3 Catalyst for Ethylene Oxide Hydration

Cu/Zno/Al2o3 Catalysts Modified by Octa-Potassium Titanate Whiskers with Ultrasonic Treatment for Methanol Synthesis