Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Effects of Calcinations Temperature on the Properties of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of Initial Precipitation Temperature on the Structural Evolution and Catalytic Behavior of Cu/SiO2 Catalyst in the Hydrogenation of Dimethyloxalate

Cu/SiO2 Catalysts Prepared by the Ammonia-Evaporation Method: Texture, Structure, and Catalytic Performance in Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Role of Copper Content and Calcination Temperature in the Structural Evolution and Catalytic Performance of Cu/P25 Catalysts in the Selective Hydrogenation of Dimethyl Oxalate

Novel Highly Efficient Cu/Hms Catalyst and Its Application to the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Textural Structure Effect Of Sio2 On The Catalytic Performance For Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Different Cu-Based Catalysts

The Influence of Copper Particle Dispersion in Cu/SiO 2 Catalysts on the Hydrogenation Synthesis of Ethylene Glycol

Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Cu/Sio2 Catalysts

Catalytic Performance and Texture of Teos Based Cu/Sio2 Catalysts for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of Calcination Temperature on Catalytic Activity and Textual Property of Cu/HMOR Catalysts in Dimethyl Ether Carbonylation Reaction

Investigation of the Structural Evolution and Catalytic Performance of the Cuznal Catalysts in the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Cu/SiO2 catalysts prepared by different methods for hydrogenolysis of dimethyl oxalate to ethylene glycol

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Efficient Tuning of Surface Copper Species of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Highly Active and Selective Cu/Sio2 Catalysts Prepared by the Urea Hydrolysis Method in Dimethyl Oxalate Hydrogenation

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Ion‐Exchange Temperature Effect on Cu/HMS Catalysts for the Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Enhanced Catalytic Performance for SiO2–TiO2 Binary Oxide Supported Cu-based Catalyst in the Hydrogenation of Dimethyloxalate

Influence of Calcination Temperature on the Dispersion Behavior and CO Oxidation Properties of CuO/γ-Al<SUB>2</SUB>O<SUB>3</SUB> Catalyst: Influence of Calcination Temperature on the Dispersion Behavior and CO Oxidation Properties of CuO/γ-Al<SUB>2</SUB>O<SUB>3</SUB> Catalyst

Influence of Calcination Temperature on CuO–CeO2/SiC Catalysts for SO3 Decomposition in the Sulfur–iodine Cycle for Hydrogen Production

Selective Hydrogenolysis of Xylitol to Ethylene Glycol and Propylene Glycol over Silica Dispersed Copper Catalysts Prepared by a Precipitation–Gel Method