An interfacial defect layer observed at (Ba,Sr)TiO3/Pt interface

H.Z. Jin,J. Zhu,P. Ehrhart,F. Fitsilis,C.L. Jia,S. Regnery,K. Urban,R. Waser
DOI: https://doi.org/10.1016/S0040-6090(02)01330-5
IF: 2.1
2003-01-01
Thin Solid Films
Abstract:Barium strontium titanate (Ba,Sr)TiO3 (BST) thin-films on Pt-substrates were studied by transmission electron microscopy. The films show a columnar structure with the grains of 10–50 nm in diameter. These are oriented parallel to the [001] direction which in turn is parallel to the film growth direction. No amorphous intergrain regions occur. The high-resolution lattice fringe pictures show for the first time that over horizontally extended areas of the interface the lattice of the BST film is modified by the introduction of a defect layer. This observation is discussed in terms of a structural origin of the so-called dead-layer effect responsible for a reduction of the film permittivity with decreasing foil thickness.
What problem does this paper attempt to address?