Abstract:Abstract Copper, permalloy, cobalt, and silicon are the materials that have been widely utilised in magnetic devices. When the size of interest is down to the nanoscale, the inter-diffusion between certain materials becomes influential. This paper studies the nanoscale friction characteristics between frictional pairs with and without inter-diffusion properties through the atomic force microscope. The distinct evolution features of nanoscale friction force when inter-diffusion is involved are discovered experimentally, which is also confirmed through theoretical analysis. Firstly, through the thin film deposition method, four pairs of contact materials (Cu–Ni 81 Fe 19 , Si–Ni 81 Fe 19 , Cu–Co, Cu–Si) are designed for friction tests, in which diffusion occurs at the interface of Cu–Ni 81 Fe 19 pair. Then, the effects of sliding velocity and loading force on the nano friction of each pair are measured. It is found that regardless of the diffusion phenomenon: (1) the adhesion force values exhibit a notable correlation to the values of the friction force; (2) the friction force in all four material pairs consistently increases with the growth of the normal loading force, although the growth rate may differ. In terms of the sliding velocity effect, the friction forces of immiscible materials (Si–Ni 81 Fe 19 , Cu–Co, and Cu–Si) are found to increase with the increasing sliding velocity. However, the friction force of Cu–Ni 81 Fe 19 , decreases with the increasing sliding velocity. Furthermore, a compositive friction model considering both the velocity and the normal force effect was proposed, which shows good agreement with the experimental results and explains the nano friction behaviour of both miscible and immiscible metals.

Effects of surface modification of nano-SiO_2 on friction properties of Cu-based friction materials

Study on Friction Properties of Cu-Based Friction Materials with Ni Coated Nano-Sio2 Particles

Effect Of Nano-Sio(2) On The Properties Of Cu-Base Friction Material

The Research on Friction and Wear Properties of Silicon Carbide and Silicon Nitride

The Microstructure and Wear Characteristics of Cu–Fe Matrix Friction Material with Addition of SiC

The effect of the modification mechanism of SiO2 in resin‐based friction materials on the mechanical and tribological performance

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

Tribological Characteristics of Silicon Nitride-chilled Cast Iron with Oil-less Lubrication

Effect of interfacial interaction between Nano-SiO2 and NBR on tribological properties of NBR water-lubricated bearings

Effect of Ni content on the wear behavior of Al-Si-Cu-Mg-Ni/SiC particles composites

Wear Mechanism of Copper-based Powder Metallurgical Friction Materials with Different Graphite Content

Effect of lubricant additives of Cu, Fe and bimetallic CuFe nanoparticles on tribological properties

Influence of Cu Content Variation on the Tribological Properties of Ni60CuMo with Sandwich-Structured Composite Coatings by Laser Cladding

Effect of Cr–Fe on friction and wear properties of Cu-based friction material

In Situ Preparation of Nano-Cu/Microalloyed Gradient Coating with Improved Antifriction Properties

Electrochemical deposition and tribological behaviour of Ni and Ni–Co metal matrix composites with SiC nano-particles

Friction and wear performance of electrospark deposited Ni/C-MoS2 self-lubricating coating

Ni/Si3N4 composite coatings and their water lubrication behaviors

Nano friction behaviour between magnetic materials and copper considering the inter-diffusion effect

Study on friction and wear behavior of copper fibers in semimetallic friction materials

Friction and wear behavior of Ti(C,N) self-lubricating cermet materials with multilayer core-shell microstructure