The Stress Analysis of the Bone Interface Around Transmandibular Dental Implants

吴润发,吴建勇,叶平,都吉秀

DOI: https://doi.org/10.3969/j.issn.1007-3957.2005.04.002

2005-01-01

Abstract:Objective: To explore the influence of the number of transimandibular implants and base-plate of titanium on the stress distribution patterns at the bone interface around the transmandibular implants.Methods: An edentulous mandible was scanned by CT to establish the model with the ANsys 5.7 software of three-dimention finite element analysis.The implants were loaded vertically along the long axis by 160N force and horizontally with 20N force directed buccal- lingual and distal-medial.The maximum compressive and tensil stress and of displacement at the area of neck of corticle bone,the area of upper1/3,middle1/3 and lower1/3 of marrow bone of the bone interface around the transmandibular implants ,and apex of implants were countted by the ANsys 5.7 software with three-dimention finite element analysis. The results were shown by histogram and stress distribution chart .Results: The maximum compressive and tensil stress at the bone interface around the transmandibular implants of tow unit with connected bar and base-plate loaded equably were located mostly on the cervical labial and lingual part of cortical bone.When loaded equably by medial-distal(left to right) stress, the maximum tensil stress appeared at the left cortical neck of the left implant,the maximum compressive stress appeared at the rigth cortical neck of the right implant. The maximum tensil stress appeared at the apex of the implants,the maximum compressive stress appeared at the neck of cortical and apex of implants when implants were loaded equably by vertical force.The maximum stress appeared at the cortical neck of both the loading implant and the unloading implant when loaded intensively, however, the stress in the unloading implant is less than which in the loading implant significantly.The characteristic of displacement distribution is corespond with that of stress distribution.Compared with the two-unit transmandibular, The characteristic of the stress and motion distribution of the four-unit transmandibular with connected bar and base-plate is correspond with but less than that of the two-unit one whenever loaded from different direction.The characteristic of the stress distribution of theimplant without base-plate is correspond with that of implant with base-plate,but the stress at the sharp point of apex of the four-unit implant with base-plate is larger and the stress at the neck or apex is less than that of implant without base-plate.Conclusions: The maximum stress at the area of cortical bone around the neck of the implant decrease with the increasing the number of the transmandibular implants or application of connecting base-plate, However the stress around the apex of the implant will be increased and the stress on the lower margin of the mandible will be decrease with the use of connecting base-plate. The results imply that increasing the mumber of implant and the application of connecting base-plate may be good clinic method for a successful shows that in the clinic use of the transmandibular implant, the number of the implants should be increased and the implants should be connected with baseplate at the margin of mandible.