Abstract:A numerical modeling study, based on 3D finite element method (FEM) simulation and 1D analytical solutions, has been carried out to evaluate the capabilities of two ac methods for measuring in-plane thermal conductivity of thin film deposited on the back of a suspended SiNx membrane setup. Two parallel metal strips are present on the top of the dielectric membrane. One strip (S1) serves as both heater and thermometer, while another one (S2) acts as thermometer only. For a modified phase shift (MPS) method, it is crucial to extract the in-plane thermal diffusivity from the phase shift of the temperature oscillation on S2. It was found that the frequency window for carrying out the data fitting became narrower as the in-plane thermal diffusivity of the composite membrane (<math>α∥,C</math>) increased, primarily due to the failure of the semi-infinite width assumption in the low frequency region. To ensure the validity of the method, the upper limit of <math>α∥,C</math> should not exceed ~1.8 × 10−5 m2 s−1 for the specific membrane dimension under consideration (1 × 1 mm2). On the other hand, inspired by a modified Ångström method proposed by Zhu recently, we suggest a new data reduction methodology which takes advantage of the phase shift on both S1 and S2 as well as the amplitude on S1. Based on the simulation results, it is expected that the non-ideality associated with the three "observables" may be at least partially canceled out. Therefore, the frequency window selection for carrying out the data fitting is not sensitive to the magnitude of <math>α∥,C</math> and the upper limit of measurable <math>αC,∥</math> can be further increased with respect to the MPS method. For typical specimen films whose in-plane thermal conductivity ranges from 0.84 W m−1 K−1 to 50 W m−1 K−1, the method proposed here yields a theoretical measurement uncertainty of less than 5%.

Effect of Underetching on Thermal Conductivity Measurement of Suspended Nanofilm

Measurement of the Thermal Conductivity of Nanodeposited Material

Experimental Study on Thermal Characteristics of Suspended Platinum Nanofilm Sensors

Estimating Error of Measuring Thermal Conductivity Using a T-Type Nano Sensor

Thermal and electrical conductivity of a suspended platinum nanofilm

Experimental Study on the In-Plane Thermal Conductivity of Au Nanofilms

Measurement of In-Plane Thermal and Electrical Conductivities of Thin Film Using a Micro-Beam Sensor: A Feasibility Study Using Gold Film

Size Effects on the Thermal Conductivity of Polycrystalline Platinum Nanofilms

Thermal barrier effect from internal pore channels on thickened aluminum nanofilm

Numerical modeling of in-plane thermal conductivity measurement methods based on a suspended membrane setup

Experimental Studies on Thermal and Electrical Properties of Platinum Nanofilms

Nonlinear Effects In Transient Electrothermal Characterization Of Anatase Tio2 Nanowires

Quantitative evaluation of the natural convection effect on thermal conductivity measurement with transient plane source method

Prediction of Size Effect on Thermal Conductivity of Nanoscale Metallic Films

Thermal Characterization of Micro/nanoscale Conductive and Non-Conductive Wires Based on Optical Heating and Electrical Thermal Sensing

Using transducerless time-domain thermoreflectance technique to measure in- and cross-plane thermal conductivity of nanofilms

Thermal And Electrical Transport Characteristics Of Polycrystalline Gold Nanofilms

Thermal and Electrical Conductivities of Polycrystalline Metallic Nanofilms Based on the Kinetic Theory

Simultaneous measurement of cross-plane thermal conductivity and interfacial thermal conductance of nano-metal films on a low thermal diffusivity substrate using TDTR

Simultaneous measurements of the specific heat and thermal conductivity of suspended thin samples by transient electrothermal method.

Direct measurement of in-plane thermal conductivity of microscale suspended thin films using a novel 3ω method