Research on Cylinder Bolt Preloading for BOG Compressors Operating at Low Temperature

DING Li-qing,WANG Lei-lei,PENG Xue-yuan

DOI: https://doi.org/10.3969/j.issn.1006-2971.2012.06.003

2012-01-01

Abstract:This paper presented the FEM simulation of stress and contact conditions of the cylinder bolts in a BOG compressor,which works with alternating pressure and temperature loads as well as preloading.Then factors,such as material property,preloading value,bolts arrangement pattern and bolts number,were discussed to study their effects on the bolt joint.The results showed that,for austenitic stainless steel,the preloading value of the bolt working at low temperature had to be larger than at normal temperature.However,the preloading values working at different temperatures can be almost the same for the bolt joint of Ni35.And as for the preloading value,larger it is,better is the connection effect,but higher is the bolts stress.It was also found that the needed preloading value tended to decrease as the bolts were located inside the cylinder.Moreover,determination of bolts number should be given consideration to both cylinder sealing condition and bolts stress condition.