Studies of Electrochemical Oxidation of Zircaloy Nuclear Reactor Fuel Cladding Using Time-Of-Flight-Energy Elastic Recoil Detection Analysis

HJ Whitlow,Y Zhang,Y Wang,T Winzell,N Simic,E Ahlberg,M Limback,G Wikmark

DOI: https://doi.org/10.1016/s0168-583x(99)00956-8

2000-01-01

Abstract:The trend towards increased fuel burn-up and higher operating temperatures in order to achieve more economic operation of nuclear power plants places demands on a better understanding of oxidative corrosion of Zircaloy (Zry) fuel rod cladding, As part of a programme to study these processes we have applied time-of-flight-energy elastic recoil detection (ToF-E ERD), electrochemical impedance measurements and scanning electron microscopy to quantitatively characterise thin-oxide films corresponding to the pre-transition oxidation regime.Oxide films of different nominal thickness in the 9-300 nm range were grown on a series of rolled Zr and Zry-2 plates by anodisation in dilute H2SO4 With applied voltages. The dielectric thickness of the oxide layer was determined from the electrochemical impedance measurements and the surface topography characterised by scanning electron microscopy. ToF-E ERD with a 60 MeV I-127(11-) ion beam was used to determine the oxygen content and chemical composition of the oxide layer. In the Zr samples, the oxygen content (O atom cm(-2)) that was determined by ERD was closely similar to the O content derived from impedance measurements from the dielectric film. The absolute agreement was well within the uncertainty associated with the stopping powers. Moreover. the measured composition of the thick oxide layers corresponded to ZrO2 for the films thicker than 65 nm where the oxide layer was resolved in the ERD depth profile. Zry-2 samples exhibited a similar behaviour for small thickness (less than or equal to 130 nm) but had an enhanced O content at larger thicknesses that could be associated either with enhanced rough surface topography or porous oxide formation that was correlated with the presence of Second Phase Particles (SPP) in Zry-2, The concentration of SPP elements (Fe, Cr. Ni) in relation to Zr was the same in the outer 9 x 10(17) atom cm(-2) of oxide as in the same thickness of metal. The results also revealed the presence of about 1 at.%, S-32 in the oxides on the Zr and Zry-2 samples which presumably originates from the electrolyte. (C) 2000 Elsevier Science B.V. All rights reserved.