Abstract:Intermittent oil-water wetting can have a significant effect on the internal corrosion of steel pipelines. This paper presents a combined experimental and molecular modeling study of several influential factors on the surface properties and corrosion behavior of mild steel in CO2 environments. The influence of different model oils (LVT-200 and Aromatic-200) and select surface-active compounds (myristic acid, cyclohexane butyric acid, and oleic acid) on the corrosion behavior of carbon steel during intermittent oil-water wetting was determined by measuring the corrosion rate after intermittent wetting cycles. The interfacial tension measurements were performed to study the incorporation of the oil phase along with surface-active molecules in the protective layer formed on the specimen surface. Results showed that the interfacial tension for an aromatic oil-water interface is lower than that for an aliphatic oil-water interface. To understand this result, molecular dynamics simulations of oil-water interfaces were performed in the presence of surface-active molecules and different oils to analyze the structure of the layer formed at the interface. The simulations supported the hypothesis that aromatic molecules are less structured at the interface, which results in the incorporation of more water molecules into the protective layer formed at the steel surface, causing a higher corrosion rate. On the other hand, the simulations revealed that myristic acid in an aliphatic oil forms a well-aligned structure at the interface, devoid of any water molecules. This is in agreement with the hypothesis that the linear molecular structure of myristic acid favors the alignment of molecules at an aliphatic oil-water interface, resulting in a lower interfacial tension and more effective corrosion mitigation as compared to the other two nonlinear compounds tested. It is concluded that an important factor controlling the corrosion behavior is the molecular structure of the oil-water interface, which is adopted by the steel surface layer through the Langmuir-Blodgett process.

Acid Neutralization by Marine Cylinder Lubricants Inside a Heating Capillary: Strong/Weak-Stick Collision Mechanisms

Temperature and acid droplet size effects in acid neutralization of marine cylinder lubricants

Universal and Stable Slippery Coatings: Chemical Combination Induced Adhesive-Lubricant Cooperation

Ostwald ripening: a decisive cause of cylinder corrosive wear

Study on the Cleanup Mechanism of Microemulsion Acid Based on Microfluidic Experiment

Experiments and Molecular Simulations to Study the Effect of Surface-Active Compounds in Mixtures of Model Oils on CO2 Corrosion during Intermittent Oil-Water Wetting

Synergistic effect between surfactant and monoacid in inhibiting the formation of naphthenates

Synergistic dispersion, adsorption, and anti-wear effects of magnesium silicate hydroxide nanomaterials and carboxylic acid

Friction control by load-induced structure modification of overbased detergent in fully formulated lubricant

Multiscale Modeling Approach to Understand Mechanism of Deposit Control by Sulfonate-Based Lubricant Detergents

Catalytically Active Oil-Based Lubricant Additives Enabled by Calcining Ni-Al Layered Double Hydroxides.

Corrosion behaviors of cylinder liner in marine diesel engine burning low sulfur fuel oil: An experimental and molecular dynamics simulation study

Competitive Surface Interactions of Critical Additives with Piston Ring/Cylinder Liner Components under Lubricated Breaking-In conditions

Mineralogical Mechanochemical Agent Assisted Reconditioning Effects and Mechanism on Worn Ferrous Surfaces

Insight into the tribological performance and mechanisms of MoN-Ag/oil solid-liquid lubrication system based on catalytic effect

Treatment of Acidic Petroleum Crude Oil Utilizing Catalytic Neutralization Technique of Magnesium Oxide Catalyst

Macroscale Superlubricity under Ultrahigh Contact Pressure in the Presence of Layered Double Hydroxide Nanosheets

Tribological performance of fatty acid, acid/amine additive mixture and ionic liquid

Effect of Nickel Acetyl Acetonate as Lubricant Additive in Base Oils with Different Molecular Structure on In-Situ Formation and Tribomechanism of Carbon-Based Tribofilms of Steel-Steel Sliding Pair

Dynamic Duo: Vibrational Sum Frequency Scattering Investigation of pH-Switchable Carboxylic Acid/Carboxylate Surfactants on Nanodroplet Surfaces

Hydrodynamic Instabilities Driven by Acid-Base Neutralization Reaction in Immiscible System