Abstract:The high temperature compressive characteristics of relatively light weight AlCoCrFeNi HEA were investigated via compression tests in a wide deformation temperature (T) range of 1073–1373 K and strain rate (ε˙) range of 10−3–1 s−1. Hot deformation led to the phase constitution transformation from the disorder BCC (A2) + order BCC (B2) at the room temperature to FCC + A2+ B2 +σ at 1073 K and 1173 K, and then to FCC + A2+B2 phase at 1273 K and 1373 K. The kinetic analysis was performed based on the flow stress data by using the hyperbolic sine law constitutive models with a higher the correlation coefficient (R2). Using combination of kinetics analysis and microstructure evolution results, it can be concluded that there was a gradual transformation of the dominant deformation mechanism from the symbiosis effects of grain boundary sliding (GBS) in fine grains and local dislocation gliding in coarse grains at 1073 K to the dislocation climbing mechanisms at 1373 K. The flow stress decreased with the decreasing strain rate and/or increasing true strain, as well as the deformation temperature. At 1073 K and 1173 K, the flow softening was primarily associated with the GBS of ultrafine dynamic recrystallization (DRX) grains in the local phase transformation regions, as well as the dynamic precipitation of FCC phases. While, the softening effect was primarily controlled by the dynamic precipitation of FCC phases and dynamic recovery (DRV) at 1273 K. When the deformation temperature rose to 1373 K, the main softening mechanisms were the continuous DRX (CDRX) and DRV, as well as the coarsening and dissolution of A2 phases Moreover, the clear serration behaviors at 1373 K/1s−1 and 1373 K/10−3s−1 were induced by the interaction effect between the dislocation and cluster.

Size-dependent high temperature deformation and microstructure

Influence of temperature on creep behavior, mechanical properties and microstructural evolution of an Al-Cu-Li alloy during creep age forming

Thermal Creep Behavior and Creep Crystallization of Al-Mg-Si Aluminum Alloys

Study on the Creep Properties and Microstructures of EW75 Alloy

High temperature deformation mechanism and microstructural evolution of relatively lightweight AlCoCrFeNi high entropy alloy

High temperature deformation behaviors of a high Nb containing TiAl alloy

Compressive creep aging behavior and microstructure evolution in extruded Al-Mg-Si alloy under different temperature and stress levels

Effect of pre-straining treatment on high temperature creep behavior of Ni-based single crystal superalloys

Study of creep deformation of metal materials with moire interferometry

Dynamic microstructural evolution of Al-Cu-Li alloys during hot deformation

An investigation on creep deformation and mechanical properties of a polycrystalline Fe-based alloy: a molecular dynamics study

Effects of Specimen Thickness and Non-Isothermal Process on Creep Behavior of AA2024 Aluminum Alloy

Effect of texture on the room temperature tensile and creep properties of Ti–6Al–4V plate with large thickness

Superior high temperature creep resistance of a cast Al–Mg–Ca-Sc alloy with multi-scale hierarchical microstructures

Room temperature creep mechanisms of Ti-6Al-4V ELI alloy with equiaxed microstructure under different applied stresses

Microstructure Evolution and Dynamic Recrystallized Model of 5083 Aluminum Alloy During Hot Deformation

Investigation of anisotropy evolution of an aluminium‐lithium alloy with increasing pre-deformation in creep age forming

Finite Element Study of the Creep Size-Effect in Thin Metal Films

Microstructure evolvement of isometry TiAl under tensile impact loadings

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature

Tensile deformation behavior of spray-deposited FVS0812 heat-resistant aluminum alloy sheet at elevated temperatures