Abstract:This study investigated toluene adsorption on natural soils. The linear partition model was found to represent the adsorption isotherm well (R2 = 0.958–0.994), compared with the Freundlich model (R2 = 0.901–0.991). Therefore, the coefficient, Kd, of the linear model indicated the adsorption capacity of soils A to F. Traditionally, Kd and the total organic carbon (TOC) content have a good linear relationship. However, this relationship was weak (correlation coefficient (r) = 0.689) when TOC values (8.43–12.9 mg/g) were low and close. To correct this deviation, this study investigated the influences of physicochemical properties, such as special surface area, mineral composition, functional groups, pH, and potentials. As soils B and C consisted of a large amount of active clayey minerals (69.4% kaolinite and 79.3% nacrite, respectively) and rich functional groups, they demonstrated the strongest adsorption capacity. Additionally, the r for pH-Kd, zeta potential-Kd, and redox potential-Kd were high, at 0.806, 0.914, and 0.932, respectively. To explore adsorption mechanisms, the adsorption thermodynamic parameter (enthalpy) was used initially to determine the forces. Combined with the analysis of soil properties, the mechanisms identified were hydrophobic interaction and hydrogen-pi bonding, involving co-adsorption with water molecules. Based on all studies, the properties were quantified and simplified by the plastic limit (PL), and TOC was simplified by soil organic matter (SOM). Then, PL and SOM were weighted by the entropy-weight method to obtain the determination factor, DF, a logarithmic parameter to replace TOC. Finally, a new model describing toluene adsorption on natural soils was established and expressed as Kd = 4.80 + 3.53DF. This new model had significantly improved the correlation between Kd and TOC (r = 0.933) and expanded the engineering adaptability.

Study on adsorption and desorption behavior of toluene by peat

Study on Adsorption of Thorium(Ⅳ)on Peat

Sorption characteristics of toluene in loess soil

Effects of Peat Application on the DTPA Extractable Cd and Cd Fractions in Two Contaminated Soils

Attenuating Toluene Mobility In Loess Soil Modified With Anion-Cation Surfactants

Thermal Desorption for Remediating PCB-contaminated Soil

Adsorption and Desorption Characteristics of Nickel to Peat

Research on dissolution performances of peat

Adsorption/desorption of Toluene on a Hypercrosslinked Polymeric Resin in a Highly Humid Gas Stream

Effect of pH for Ni2+ adsorption kinetics on peat

Absorption and desorption of gaseous toluene by an absorbent microcapsules column.

SURFACE ACID-BASE PROPERTIES OF PEAT

Adsorption of toluene on various natural soils: Influences of soil properties, mechanisms, and model

Modelling and Prediction of Toluene Adsorption Saturation Basing on Characteristic Values of Activated Carbons

Hierarchical Porous Carbon As a Highly Efficient Adsorbent for Toluene and Benzene

The acid–base, morphological and structural properties of new biosorbent obtained by oxidative hydrothermal treatment of peat

Application of SPME-GC/MS to Study the Sorption of Organophosphate Esters on Peat Soil

Enhancing biodegradation of aged hydrocarbon-contaminated soils through toluene addition: assessing effects on solid and slurry phase treatments

Pyrolysis Char Derived from Waste Peat for Catalytic Reforming of Tar Model Compound

Preparation of porous carbon based on partially degraded raw biomass by Trichoderma viride to optimize its toluene adsorption performance

Studies on Toluene Adsorption Performance and Hydrophobic Property in Phenyl Functionalized KIT-6