Abstract:The geometry of a solar cavity receiver affects the absorption of incident solar energy and the temperature distribution on the absorber tube panels, and hence affects the operation stability and efficiency of the solar receiver. A modified combined computational method was proposed to investigate the thermal performance of the three dimensional (3-D) molten salt cavity models in steady state. This computational method was also used to calculate the thermal performance of the receiver in the Molten-Salt Subsystem/Component Test Experiment (MSS/CTE) in the United States, and the results agree well with published data. Molten salt cavity receivers with different heights were studied. The results show that a too-low or too-high height leads to low thermal efficiency of a receiver. Therefore, appropriate heights shall be chosen to enable receivers achieve relatively high efficiencies and reach low temperatures. The molten salt cavity receivers with different cross-sections in the chosen heights were then studied, to obtain a high-efficiency cavity receiver structure without increasing the inner surface area or the depth of the cavity, under the condition that the molten salt cavity receivers were in the same perimeter of the cross-section, aperture size, cavity height, tube panel and fluid flow layouts but different cavity depths. When-only the lengths of the back walls next to the side walls had been increased, the thermal efficiency decreased first and then increased with the depth decreasing, which reached the lowest value when the depth was 2.71 m. When the depth of the modified receiver is small enough, its thermal efficiency can be higher than that of the MSEE receiver. When only the lengths of the two walls adjacent to the aperture had been increased, the thermal efficiency increased with the depth decreasing, and was always higher than that of the receiver in the Molten-salt Electric Experiment (MSEE) in the United States. The thermal efficiency difference between the two arrangements of the side walls decreased with a decrease in the cavity depth. The cross-section of the MSEE receiver is similar to that of the receiver in the molten salt electric experiment by Sandia National Laboratories. Under the condition of side-on wind at a velocity of 8.3 m/s, the thermal efficiency of the modified cavity with the minimum depth is 2% higher than that of the MSEE cavity with the maximum depth. The convective heat loss is 3.1% lower, while the radiative and reflective heat losses changed slightly. Therefore, the modified cavity in the present study is capable of achieving a higher efficiency with a less depth. (C) 2017 Elsevier Ltd. All rights reserved.

Numerical study on the performance of spherical cavity solar receiver

The Numerical Investigation on Optical Efficiency and Heat Flux Distribution of Conical Cavity Receiver

Numerical simulation of the heat flux distribution in a solar cavity receiver

Numerical Study on Thermal Performance of a Solar Cavity Receiver with Different Depths

Radiation Performance of Dish Solar Concentrator/Cavity Receiver Systems

PERFORMANCE SIMULATION OF SOLAR CAVITY RECEIVER

Numerical Simulation and Experiment Research of Radiation Performance in a Dish Solar Collector System

Numerical Investigation on Uniformity of Heat Flux for Semi-Gray Surfaces Inside a Solar Cavity Receiver

Solar-thermal conversion investigation using surface partition method for a cavity receiver with helical pipe

Numerical Study of Radiation Characteristics in a Dish Solar Collector System

Numerical Study on Complex Coupled Heat Transfer Mechanism of the Pressurized Volumetric Receiver

Experimental Investigation of Thermal Performance Enhancement of Cavity Receiver with Bottom Surface Interior Convex

Numerical study of heat transfer characteristics in the solar receiver tube combined with MCRT method

Three-dimensional Numerical Study of Heat Transfer Characteristics in the Receiver Tube of Parabolic Trough Solar Collector

Experimental investigation on heat-transfer characteristics of a cylindrical cavity receiver with pressurized air in helical pipe

Numerical Evaluation on the Thermal Performance of the Solar External Cylinder Receiver Using Monte Carlo Ray-Tracing Algorithm

Structural Optimization Design And Radiation Performance Simulation In A Dish Solar Collector System

Numerical Investigation on the Thermal Performance of Molten Salt Cavity Receivers with Different Structures

Theoretical and Experimental Analysis on Efficiency Factors and Heat Removal Factors of Fresnel Lens Solar Collector Using Different Cavity Receivers

Study On Trough Receiver For Linear Concentrating Solar Collector

An experimental investigation on thermal and optical analysis of cylindrical and conical cavity copper tube receivers design for solar dish concentrator