Abstract:Recently tetrapod piled jacket (TPJ) foundations are considered as a promising solution for offshore wind turbines in waters with depths ranging from 20 m to 50 m. This paper presents a numerical study into the monotonic lateral loading behaviour of TPJ foundations in medium sand, in terms of overall load-displacement responses of TPJ foundations and internal force within individual corner piles as well as pile-soil interaction. The results of previous centrifuge model tests are used to provide high-quality verification for the development of a 3D finite element model established by ABAQUS. A series of parametric studies is then carried out to look into more detailed response of TPJ foundations subjected to lateral loads, including the influence of spacing and slenderness ratio of piles, loading height as well as soil friction angle. The numerical results show that there are two various deformation models of TPJ foundations during lateral loading. One is shearing dominated deformation model under smaller loads, while another one is overturning dominated model under larger loads. Moreover, the lateral soil-pile interaction is found to be greatly influenced by enhancing/weakening effects of the axial forces of individual piles. The cause of this phenomenon is primarily due to the change in soil stress induced by pile vertical movement and radial deformation. To quantify this effect on pile-soil interaction of TPJ foundation, an enhancement factor Gamma(s), defined as the ratio of the soil resistance on downwind piles to that on upwind piles, is proposed. Consequently, the relationship between Gamma(s), depth of influence zone z(c )and four parameters are carefully investigated. For simplicity, the Gamma(s) is assumed constant and independent with pile lateral deflection as well as soil depths, based on which the values for Gamma(s) and z(c) are recommended for practical design uses. It is highlighted in the present study that these values should be chosen based on the specific loading conditions to provide much safer and more robust design for TPJ foundations.

On Determination of Pile Length with Parallel Seismic Testing for Existing Structures

STUDY ON PILE LONGITUDINAL VIBRATION CONSIDERING EFFECT OF UNDERGROUND WATER LEVEL

A Study on Longitudinal Vibration Behavior of Inhomogeneous Pile Embedded in Layered Unsaturated Soils

Multipoint Traveling Wave Decomposition Method and Its Application in Extended Pile Shaft Integrity Test

PS Wave Based Parallel Seismic Test for Pile Length Assessment

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Theoretical Basis and Numerical Simulation of Parallel Seismic Test for Existing Piles Using Flexural Wave

Discussion of: A study on the application of the parallel seismic method in pile testing

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

3-D Finite Element Analysis of Parallel Seismic Testing for Integrity Evaluation of In-Service Piles

3d Finite Element Analysis Of Parallel Seismic Tests For Integrity Of Piles Of Existing Structures

Selection of Pile Testing Signals for Parallel Seismic Test

Analytical Model for Laterally Loaded Soil-Extended Pile Shaft Applied to Verifying the Applicability of Lateral PS Method

A 3D analytical model for distributed low strain test and parallel seismic test of pipe piles

Comparison of Parallel Seismic and Reflected Wave Tests for Piles

Studies on Parallel Seismic Testing for Integrity of Cemented Soil Columns

Dynamic Response of a Defect Pile in Layered Soil Subjected to Longitudinal Vibration in Parallel Seismic Integrity Testing

Seismic Performance Analyses of Pile-supported Transmission Tower-line Systems Subjected to Depth-varying Spatial Ground Motions

Numerical Investigation on the Lateral Loading Behaviour of Tetrapod Piled Jacket Foundations in Medium Dense Sand

Dynamic Soil Reactions Around a Beam-on-Multiple-Piles Structure and Their Application in the Parallel Seismic Integrity Test

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings