Abstract:The ZnO-0.5SiO2 ceramics were prepared by conventional solid oxide process method.For the ZnO-0.5SiO2 system,the effect of A-site substitution on sintering and dielectric properties was systematically investigated.According to the XRD analysis,it was found that the maximum solubility of Mg2+ is 0.5:when the solubility,x(Mg),is lower than 0.5,the(Zn1-x,Mgx)2SiO4 phase formed in the ceramics;but if the solubility is higher than 0.50,the second phases of Mg2SiO4 and Mg2SiO3 formed in the system.Thus,it is reasonable to deduce that the solubility limitation has a significant influence on the formation of the phases in the ceramics.The influence of the x(Mg) value on the microstructure property of the ceramics was revealed by the SEM observation.The decrease of the sintering temperature was explained by considering the introduction of the Mg2+,which led to the distortion of the crystal lattice or the formation of defects in the ceramics.For x(Mg)≤0.5,the dielectric constant varied a little and the quality factor shown higher values.For x(Mg)0.5,the dielectric constant increased but the quality factor decreased sharply.It was verified that the(Zn1-x,Mgx)2SiO4(x=0.1～0.3) ceramics sintered at 1 275℃ exhibited good microwave dielectric properties;the dielectric constant,the quality factor and the temperature coefficient of resonant frequency are 6.19～6.23,48 000～53 000 GHz and-50×10-6～-60×10-6/℃,respectively.

Synthesis and Microwave Dielectric Properties of (Ca_(0.7)Mg_(0.3))SiO_3 Ceramic by Sol-Gel Process

Synthesis and Microwave Dielectric Properties of (Ca<SUB>0.7</SUB>Mg<SUB>0.3</SUB>)SiO<SUB>3</SUB>Ceramic by Sol-Gel Process: Synthesis and Microwave Dielectric Properties of (Ca<SUB>0.7</SUB>Mg<SUB>0.3</SUB>)SiO<SUB>3</SUB>Ceramic by Sol-Gel Process

Synthesis and microwave dielectric properties of (Ca0.7Mg0.3)SiO3 nanopowder prepared at low temperature

Synthesis and Microwave Dielectric Properties of CaSiO3 Nanopowder by the Sol–gel Process

Synthesis and Microwave Dielectric Properties of CaO–MgO–SiO2 Submicron Powders Doped with Li2O–Bi2O3 by Sol–gel Method

Unleashing the Potential of Mg2SiO4-based Ceramics for Millimeter-Wave Applications: Achieving Ultra-Low Loss with Enhanced Temperature Stability Through Heterovalent Ion Substitution

Influence of CaO content by mass in sintering aid and sintering temperature on the properties of Al2O3-based microwave ceramic materials

Low-Temperature Sintering and Microwave Dielectric Properties of (ca0.9mg0.1)sio3 Ceramic with Li2co3 Addition

Low-temperature sintering and microwave dielectric properties of CaMg1−xLi2xSi2O6 (x = 0−0.3) ceramics

Preparation of Low Temperature Cofired CaO-MgO-SiO2 Microwave Ceramics Doped with Additives by Sol-Gel Method

Effect of A-site Substitution on Sintering and Dielectric Properties of ZnO-0.5SiO2 Ceramics

(Ca1−xmgx)sio3: A Low-Permittivity Microwave Dielectric Ceramic System

Effect of raw materials type on the sintering ability and microwave dielectric properties of Mg2.15Al4Si5O18 ceramics

Modification of Low Temperature Sintered CMS Microwave Dielectric Ceramics Doped with Nanopowder

Effects Of Catio(3)On Microstructures And Properties Of (1-X) Znal2o4-Xmg(2) Tio4 (X=0.1) Microwave Dielectric Ceramics

Microwave dielectric properties of Mg2SiO4–Ca1−ySm2y/3TiO3 composite ceramics

Effect of molding process on sintering and properties of (Mg1-xZnx)2SiO4 high-frequency dielectric ceramics

Glass-free CaMg0.9−xLi0.2MnxSi2O6 ceramics with enhanced dielectric properties for microwave and THz frequency applications

Ultra low loss (Mg 1 − x Ca x ) 2 SiO 4 dielectric ceramics (x = 0 to 0.15) for millimeter wave applications

Microwave dielectric properties of Ca1-Sr MgSi2O6 ceramics

Low-temperature sintering and microwave dielectric properties of LiF-doped CaMg1-xZnxSi2O6 ceramics