Abstract:Complexation with nitrite ions in aqueous medium was used to prepare highly dispersed Pd° particles supported on alumina. It has been possible to obtain catalysts with different Pd loading keeping the particle size lower than 1nm as shown by HRTEM, chemisorption, or extended X-ray absorption fine structure (EXAFS) characterizations, and as a consequence with different particle surface density. We observed that electronic properties measured by IR(CO) or X-ray photoelectron spectroscopy (XPS) measurements are strongly influenced by this last parameter and that the origin of these variations can be related to the different strengths of the interactions of the palladium precursor with the alumina surface sites as shown by low temperature CO adsorption followed by FTIR spectroscopy. On increasing Pd loading, saturation of unsaturated Lewis surface sites follows their acid strength: the more acidic ones are the first to react as germination sites, followed by the medium and finally the weaker sites. These different interactions may explain the variation of electronic properties of such small reduced particles which appears to be very sensitive to the chemical nature of their initial germination site on the oxide support. On the other hand, no such effects were observed on changing the type of alumina (δ or γ) support, in agreement with the principle of the synthesis method which tends to limit strong interaction with the support. Comparison with Pd° particles with the same particle size and particle surface density but prepared with the well known grafting of acetylacetonate precursor shows marked differences in terms of electronic properties followed by CO FTIR. This result illustrates the possibility to prepare highly dispersed Pd particles with different physico-chemical properties.

Dispersion of Active Au Nanoparticles on Mesoporous Sba-15 Materials

Preparation of Au Nanoparticles on Surface of Two Supports by Adsorption Phase Synthesis

Preparation of Au Catalyst on Modified Sio2 Via Adsorbed-Layer Nanoreactor Technique

Preparation of Highly Active Silica-Supported Au Catalysts for Co Oxidation by A Solution-Based Technique

High Density Gold Nanoparticles Within Three-Dimensionally Mesoporous SBA-15: Adsorption Behavior and Optical Properties.

Preparation of Au Nanocolloids by in Situ Dispersion and Their Applications in Surface-Enhanced Raman Scattering (sers) Films

Influences of Synthesis Conditions and Mesoporous Structures on the Gold Nanoparticles Supported on Mesoporous Silica Hosts

A General and Feasible Method for the Fabrication of Functional Nanoparticles in Mesoporous Silica Hollow Composite Spheres

Highly dispersed Au, Ag and Cu nanoparticles in mesoporous SBA-15 for highly selective catalytic reduction of nitroaromatics

Dispersion of Nano Nickel Particles over SBA-15 Modified by Carbon Films on Pore Walls

Preparation and Characterization of Ag Nanoparticles Embedded in Hierarchically Porous Monolithic Silica

Controllable Preparation of Monodisperse Mesoporous Silica from Microspheres to Microcapsules and Catalytic Loading of Au Nanoparticles

Synthesis of Stable Au–SiO2 Composite Nanospheres with Good Catalytic Activity and SERS Effect

Adsorption and Catalytic Activity of Gold Nanoparticles in Mesoporous Silica: Effect of Pore Size and Dispersion Salinity

Comparative Studies Between Synthetic Routes of Sio2@Au Composite Nanoparticles

Gold Nanoparticle Stabilization Within Tailored Cubic Mesoporous Silica: Optimizing Alcohol Oxidation Activity

Synergistic adsorption of As(V) from aqueous solution onto mesoporous silica decorated orderly with Al2O3 and Fe2O3 nanoparticles

Facile And Controllable Fabrication Of Gold Nanoparticles-Immobilized Hollow Silica Particles And Their High Catalytic Activity

Synthesis of thermally stable and highly active bimetallic Au-Ag nanoparticles on inert supports

Synthesis of highly dispersed palladium alumina supported particles: Influence of the particle surface density on physico-chemical properties

Study on Modification and Dispersion of Nano‐silica