Chitosan-coated silica beads as immobilized metal affinity support for protein adsorption

Q.-H Shi,Y Tian,X.-Y Dong,S Bai,Y Sun
DOI: https://doi.org/10.1016/S1369-703X(03)00095-0
IF: 3.9
2003-01-01
Biochemical Engineering Journal
Abstract:Chitosan was used for the surface coating of porous silica beads and copper(II) ions were immobilized to the chitosan layer to prepare an immobilized metal affinity (IMA) absorbent for protein adsorption. The amount of chitosan adsorbed on silica bead was about 8.5mg/g of wet beads. Nonspecific adsorption of chitosan-coated silica beads decreased significantly from 0.23 to less than 0.08mmol/l after the surface coating. A proper cross-linking ratio of glutaraldehyde was determined by investigating the adsorption of Cu2+ and then BSA. Copper(II) ions were loaded to the chitosan-coated silica at 48mmol/l. BSA adsorption to this IMA adsorbent showed a maximum (0.91mmol/l) at liquid phase pH of 5.0, close to its isoelectric point. The adsorbed protein could be dissociated by increasing liquid phase pH 8.0, indicating the reversibility of the adsorption. Most importantly, the chitosan-coated silica showed significantly enhanced stability in alkaline solutions, as demonstrated by the long-term treatment in 0.1mol/l sodium hydroxide solution and repeated uses for protein adsorption.
What problem does this paper attempt to address?