Abstract:Journal of Composite Materials, Ahead of Print. Thermoplastic composite materials are being increasingly used in many domains, such as automotive, marine and aeronautics. This growing interest is due to the relatively good mechanical properties and the recycle-ability of these materials. In various heat assisted forming technologies, thermoplastic composites may be subjected to severe conditions such as high temperatures, complex strain paths and potentially significant strain rates. This is expected to highly influence the overall behavior of these materials and make the characterization of their mechanical behavior more complicated. In this paper, the mechanical behavior of discontinuous glass fiber reinforced polypropylene composite is investigated at temperatures going from room temperature (RT) to 120°C and strain rates ranging from quasi-static conditions to 10 s−1 by means of uniaxial tensile tests. The effect of material orientation is also investigated at RT and quasi-static strain rate of 0.001 s−1 pointing out a clear anisotropic behavior. The tensile properties including Young's modulus E, ultimate tensile strength σult and strain at failure ɛf are determined based on the Standard ISO-527 reporting an obvious sensitivity of the material to temperature and strain rate. Based on literature review, the phenomenological isotropic constitutive model of G'Sell and Jonas, originally designed for unreinforced semi-crystalline polymers, is selected to describe the mechanical behavior of the studied material. A modification of the original constitutive equation is proposed for a better representation of the overall behavior of the material at different temperature and strain rate conditions. Finally, the validity of this phenomenological law calibrated by means of the uniaxial tests, is evaluated for an equi-biaxial loading state close to that encountered by the material during heat assisted sheet forming process. The significant disagreement highlighted between numerical and experimental results proved that the uniaxial tensile tests are not sufficient to characterize the behavior of the material when a complex loading condition is imposed.

Squeeze Flow Testing of Glass Mat Thermoplastic Material

Intrinsic Versus Extrinsic Effects on Serrated Flow of Bulk Metallic Glasses

Experimental and predictive analysis of the molding behavior of a PA6 glass mat thermoplastic (GMT)

Thermomechanical Coupling in Glassy Polymers: an Effective Temperature Theory

Testing, Characterizing, and Forming of Glass Twill Fabric/polypropylene Prepregs

Transverse squeeze flow of thermoplastic composite tape during in-situ consolidation via automated fiber placement

Injection molding simulation of short fiber reinforced thermosets with anisotropic and non-Newtonian flow behavior

Thermo-visco mechanical behavior of glass fiber reinforced thermoplastic composite

A Squeeze Flow Problem with A Navier Slip Condition

Experimental Characterization of Plastic Flow Initiation in a Bulk Metallic Glass Via Intermittent Compression Test

Squeeze flow behaviors of magnetorheological plastomers under constant volume

Non-isothermal direct bundle simulation of SMC compression molding with a non-Newtonian compressible matrix

Experimental Study of Glass-Fiber Mat Thermoplastic Material Impact Properties and Lightweight Automobile Body Analysis

Squeeze Flow Behavior of Shear Thickening Fluid under Constant Volume

Manufacturing Process Effect on the Mechanical Properties of Glass Fiber/Polypropylene Composite Under High Strain Rate Loading: Woven (W-GF-PP) and Compressed GF50-PP

Method Development to Evaluate Melting Behavior of Glass Fiber-Reinforced Syndiotactic Polystyrene Composites in the Presence of Pressure Loading

Flow Characteristics of Microglass Fiber Suspension in Polymeric Fluids in Spherical Gaps

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements

Determination of Flow Curve and Plastic Anisotropy of Medium-Thick Metal Plate: Experiments and Inverse Analysis

On the design of test molds based on unidirectional saturated flows to measure transverse permeability in liquid composite molding

Traversing with quantitative fidelity through the glass transition of amorphous polymers: Modeling the thermodynamic dilatational flow of polycarbonate