Abstract:Structural evolution of two propylene 1-butene random copolymer (iPPBu) films with different initial crystalline morphology during uniaxial deformation were investigated by synchrotron wide-angle and small-angle X-ray scattering (WAXS/SAXS), Fourier-transform infrared (FTIR) spectroscopy. The iPPBu with α crystal crystallized via mesophase exhibits a nodular morphology, while melt-crystallized iPPBu exhibits a characteristic spherulitic structure. The initial crystalline morphology has been found to exert influence on the structural evolution of the samples, including cavitation, orientation behavior of molecular chains in crystalline and amorphous phases, the occurrence of mesophase, and reduction in crystallinity, etc. Compared with the iPPBu with spherulitic morphology, no obvious cavitation was observed around the yield point in iPPBu with nodular morphology. Moreover, the variation rate of crystallinity with respect to draw ratio is smaller in the iPPBu with nodular morphology. A plausible reason for the phenomenon is that the iPPBu with nodular morphology has the lower lateral extension of crystallites. The onset draw ratio (λ onset) of α-crystal-to-mesophase transition in sample with nodular morphology is larger than that in the sample with spherulitic morphology. The molecular chains tend to be aligned perpendicular to the stretching direction in iPPBu with spherulitic morphology around yield point. This is attributed to the bending and separation of the lamellae with the normal parallel to the tensile direction. However, this phenomenon is not observed in the iPPBu with nodular morphology. In the strain-hardening regime, the strain hardening modulus G p of iPPBu with nodular morphology is higher than that of iPPBu with spherulitic morphology, which results from the more cross-linking points and more tie chains in highly oriented the amorphous phase of the former. A deformation mechanism is proposed to understand the role played by the initial morphology of iPPBu based on the crystal transition, variation in crystallinity, cavitation, and orientation.

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. 2. Molecular Orientation During Necking Process of Isotactic Polypropylene

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. Part Iii: Influence of Morphology on Molecular Orientation of Isotactic Polypropylene Films Subjected to Uniaxial Stretching

Inhomogeneous Deformation of Microcrystalline Region in Isotactic Polypropylene Film Revealed by A Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress

Molecular Orientations and True Stress−Strain Relationship in Isotactic Polypropylene Film

Application of an Interpenetrating Network Model to the Necking in the Microcrystalline Region in Four Annealed Isotactic Polypropylene Films Subjected to Uniaxial Stretching at Room Temperature

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

Application of an interpenetrating network model to the solid deformation of a quenched isotactic polypropylene film

Segmental Orientations and Deformation Mechanism of Poly(Ether-Block-Amide) Films

Aging-dependent Strain Localization in Amorphous Glassy Polymers: from Necking to Shear Banding

In-situ FTIR imaging on the plastic deformation of iPP thin films

The Spatial Correlation Between Crystalline and Amorphous Orientations of Isotactic Polypropylene During Plastic Deformation:An in Situ Observation with FTIR Imaging

Deformation-induced highly oriented and stable mesomorphic phase in quenched isotactic polypropylene

Unfolding of Isotactic Polypropylene under Uniaxial Stretching

Spatial distribution of crystal orientation in neck propagation: An in-situ microscopic infrared imaging study on polyethylene

Tensile deformation mechanism of propylene-1-butene random copolymer: The role of initial crystalline morphology

In Situ Microscopic Infrared Imaging Study On Deformation-Induced Spatial Orientation And Phase Transition Distributions Of Pa12

Stress-induced Microphase Separation of Interlamellar Amorphous Phase in Hard-Elastic Isotactic Polypropylene Film

Crystallinity and Crystallographic Texture in Isotactic Polypropylene during Deformation and Heating

Stretch-induced structural evolution of pre-oriented isotactic polypropylene films: An <i>in-situ</i> synchrotron radiation SAXS/WAXS study

Deformation-Induced Crystallization Behavior of Isotactic Polypropylene Sheets Containing a β-Nucleating Agent under Solid-State Stretching

In Situ Ftir Spectroscopic Study of the Conformational Change of Isotactic Polypropylene During the Crystallization Process