Abstract:Structural transitions of polyamide 46 (PA46) films during the tensile stretch at temperatures from 37 to 249 °C were studied using in situ synchrotron radiation wide-angle X-ray diffraction (SR-WAXD) and Fourier transform infrared (FTIR) techniques. The structural evolution during the stretch at different temperatures can be roughly divided into three regions. In region I (37 ≤ T < 180 °C), stretch enlarges the d-spacing gap between the (100) and (010/110) planes of α phase (triclinic), which is opposite to that during heating. In region II (180 ≤ T < 230 °C), stretch induces a reverse Brill transition, which is characterized by the single diffraction of γ phase (pseudohexagonal) splitting into two diffractions of α phase, while further increasing the strain drives the two split diffractions to transform to a single broad diffraction. As in situ FTIR measurements reveal the continuously increasing content of trans conformation, we speculate that stretch may induce a new form, which is an intermediate structure close to both α and γ phases (named α′ phase) at large strain. In region III (230 ≤ T ≤ 249 °C), the γ phase may skip the α phase and directly transform into the α′ phase. The nonequilibrium crystal phase diagrams of PA46 were constructed in the strain–temperature space and true stress–temperature space. Current results demonstrate that stretch plays a countereffect of heating on the Brill transition of PA46.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.macromol.0c00542?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.macromol.0c00542</a>.Crystal structure confirmation of PA46; the possible unit cell orientation and WAXD pattern of spherulitic aggregates; 1D WAXD integration profiles and the corresponding quantitative results; and in situ FTIR curves and stress–strain curves for FTIR experiments (<a class="ext-link" href="/doi/suppl/10.1021/acs.macromol.0c00542/suppl_file/ma0c00542_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

In Situ Microscopic Infrared Imaging Study On Deformation-Induced Spatial Orientation And Phase Transition Distributions Of Pa12

Aging-dependent Strain Localization in Amorphous Glassy Polymers: from Necking to Shear Banding

Spatial distribution of crystal orientation in neck propagation: An in-situ microscopic infrared imaging study on polyethylene

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. 2. Molecular Orientation During Necking Process of Isotactic Polypropylene

Inhomogeneous Deformation of Microcrystalline Region in Isotactic Polypropylene Film Revealed by A Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress

Segmental Orientations and Deformation Mechanism of Poly(Ether-Block-Amide) Films

A Constitutive Model for Strain Hardening Behavior of Predeformed Amorphous Polymers: Incorporating Dissipative Dynamics of Molecular Orientation

Application of an Interpenetrating Network Model to the Necking in the Microcrystalline Region in Four Annealed Isotactic Polypropylene Films Subjected to Uniaxial Stretching at Room Temperature

Molecular Orientations and True Stress−Strain Relationship in Isotactic Polypropylene Film

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. Part Iii: Influence of Morphology on Molecular Orientation of Isotactic Polypropylene Films Subjected to Uniaxial Stretching

In-situ FTIR imaging on the plastic deformation of iPP thin films

Studying deformation behavior of a single spherulite with in-situ infrared microspectroscopic imaging

Application of an interpenetrating network model to the solid deformation of a quenched isotactic polypropylene film

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Nanostructure and Mechanical Measurement of Highly Oriented Lamellae of Melt-Drawn HDPE by Scanning Probe Microscopy

Strain-Induced Form Transition and Crystallization Behavior of the Transparent Polyamide

Phase morphology evolution upon melt annealing treatment and corresponding mechanical performance of impact-resistant polypropylene copolymer

Deformation and Molecular Orientation in Films of Metallocene Polypropylene, Ethylene-Butylene Rubber, and Their 80/20 (W/W) Blend Revealed by the Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism, Macroscopic Stress, and Mesoscale Strain

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements

Structure Evolution of Oriented Poly( l -lactic acid) Ultrathin Films during Deformation

Stretch-Induced Reverse Brill Transition in Polyamide 46