Abstract:Background Measurement of Computed Tomography (CT) beam width is required by accrediting and regulating bodies for routine physics evaluations due to its direct correlation to patient dose. Current methods for performing CT beam width measurement require special hardware, software, and/or consumable films. Today, most 100‐mm pencil chambers with a digital interface used to evaluate Computed Tomography Dose Index (CTDIvol) have a sufficiently high sampling rate to reconstruct a high‐resolution dose profile for any acquisition mode. Purpose The goal of this study is to measure the CT beam width from the sampled dose profile under a single helical acquisition with the 100‐mm pencil chamber used for CTDIvol measurements. Methods The dose profiles for different scanners were measured for helical scans with varying collimation settings using a 100‐mm pencil chamber placed at the isocenter and co‐moving with the patient table. The measured dose profiles from the 100‐mm pencil chamber were corrected for table attenuation by extracting a periodic correction function (PCF) to eliminate table interference. The corrected dose profiles were then deconvolved with the response function of the chamber to compute the beam profile. The beam width was defined by the full width half maximum (FWHM) of the resulting beam profile. Reference dose profiles were also measured using Gafchromic film for comparison. Results The beam widths, estimated using the innovative deconvolution method from the 100‐mm pencil chamber, exhibit an average percentage difference of 1.6 ± 1.8 when compared with measurements obtained through Gafchromic film for beam width assessment. Conclusion The proposed approach to deconvolve the pencil chamber response demonstrates the potential of obtaining the CT beam width at high accuracy without the need of special hardware, software, or consumable films. This technique can improve workflow for routine performance evaluation of CT systems.

2-D Beam Profile Measurement Based on Ct Algorithm with Rotating Multi-Wire Target

2-D Low Energy Electron Beam Profile Measurement Based on Computer Tomography Algorithm with Multi-Wire Scanner

Development of Equipment for Simultaneously Measuring Two-dimensional Rotation Angles of the Linear Guide Track

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Beam 2-D Phase-Space Measurement with Ct and Cerenkov Radiation "double Imaging Method"

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Transverse profile tomography of a high current proton beam with a multi-wire scanner

Beam distribution reconstruction simulation for electron beam probe

Determining Beam Transverse Absolute Position by Triangulation of Multi-Electrode Signal Phase Differences

A dual-probe three-dimensional profile measurement system

Four-dimensional Phase Space Measurement Using Multiple Two-Dimensional Profiles

Radiographic Imaging with a Linear X-Ray Source and Multi-Row Detector

An Electron Beam Linear Scanning Mode for Industrial Limited-Angle Nano-Computed Tomography.

SU-DD-A4-05: Development of a Tetrahedron Beam Computed Tomography Benchtop System with a 75 Pixel Field Emission X-Ray Tube: Collimator Design and Image Reconstruction

Transverse Phase Space Measurement Based On Computerized Tomography

Dual Energy CT Imaging in Cone-Beam Micro-Ct for Improved Attenuation Coefficient Measurement

Stationary Micro-Ct Scanner Using a Distributed Multi-Beam Field Emission X-Ray Source: a Feasibility Study

A New Measurement Of Electron Beam Emittance With Cerenkov Radiation "Double Imaging" Method

The use of pencil ionization chamber with temporal readout capabilities to measure CT beam full width half maximum

Automated pinhole-aperture diagnostic for the current profiling of TWT electron beams

Measurement of power density distribution and beam waist simulation for electron beam