Abstract:PURPOSE Sample radiation damage is one of the main drawbacks limiting applications of the x-ray phase-contrast imaging method. Recently, for x-ray grating-based phase contrast imaging, the reverse projection (RP) method has been proposed by Zhu et al. [Proc. Natl. Acad. Sci. U.S.A. 107, 13576-13581 (2010)]. Compared to the conventional phase stepping technique, the RP method allows a strong reduction of the exposure time and minimization of the errors induced by mechanical vibrations. However, so far, it has only been considered for parallel beam illumination, typical of a synchrotron radiation source. In this paper, a generalization of the RP method from parallel beam geometry to fan beam geometry was presented and discussed. METHODS Within parallel beam geometry, the RP method utilizes the conjugate characteristic between reverse projection images. Nevertheless, this characteristic is not directly satisfied for fan beam geometry. In this study, a phantom composed of known materials was constructed and the projection images of the phantom were calculated in a fan beam geometry. By considering single ray, the conjugate images of the projection images were derived from the projection dataset. After that, using the modified RP method the authors retrieved phase and absorption information from paired images. RESULTS Extracted phase and absorption information of the phantom were in good agreement with theoretical values. Additionally, the slice reconstruction was performed and the results turned out to be in the authors' expectation. CONCLUSIONS Theoretical calculations and numerical simulations confirm both feasibility and validity of the RP method under fan beam illumination. Because this method is simple, fast, and releases a relatively low dose, the authors believe that this research is very useful for the x-ray phase contrast imaging applications in clinical diagnosis, bioresearch, and industrial nondestructive testing.

Beam 2-D Phase-Space Measurement with Ct and Cerenkov Radiation "double Imaging Method"

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Transverse Phase Space Measurement Based On Computerized Tomography

A New Measurement Of Electron Beam Emittance With Cerenkov Radiation "Double Imaging" Method

2-D Beam Profile Measurement Based on Ct Algorithm with Rotating Multi-Wire Target

2-D Low Energy Electron Beam Profile Measurement Based on Computer Tomography Algorithm with Multi-Wire Scanner

Registration of On-Board X-ray Images with 4DCT: A Proposed Method of Phase and Setup Verification for Gated Radiotherapy

Determining Beam Transverse Absolute Position by Triangulation of Multi-Electrode Signal Phase Differences

Four-dimensional Phase Space Measurement Using Multiple Two-Dimensional Profiles

A New Method to Retrieve Phase Information for Equiangular Fan Beam Differential Phase Contrast Computed Tomography.

Radiographic Imaging with a Linear X-Ray Source and Multi-Row Detector

Rotating and Semi-Stationary Multi-Beamline Architecture Study for Cardiac CT Imaging

Transverse Phase Space Tomography Using a Solenoid Applied to a Thermal Emittance Measurement

Beam Hardening Correction for Interior Tomography Based on Exponential Formed Model and Radon Inversion Transform

Tetrahedron beam imaging with a multi‐pixel thermionic emission X‐ray source and a photon‐counting detector: A benchtop experimental study

Research of Direct Volume CT with Point Detectors and Trough-like X-ray Source Scanning at Two Positions

Four-Dimensional Phase-Space Reconstruction of Flat and Magnetized Beams Using Neural Networks and Differentiable Simulations

Experimental Research on Two-Phase Flow Visualization Using A Low-Energy Gamma Ct System with Sparse Projections

Data Incompleteness in Radon Space for Circular Cone-Beam Reconstruction

A Straight-Line Trajectory Tomography Method Based on Multiple Tilted X-Ray Cone-Beams

Cycloidal-spiral sampling for three-modal x-ray CT flyscans with two-dimensional phase sensitivity