Abstract:With the growth of the new energy industry, the requirements for manganese have increased significantly. In this paper, the method of manganese extraction from pyrolusite using ammonium sulfate roasting and water leaching was presented. At the optimal process parameters: mass ratio of (NH4)2SO4 to pyrolusite of 2:1, the roasting temperature of 420 degrees,C and duration of 120 min, the leaching efficiency of Mn and Fe was 94.55% and 54.38%, respectively. The mechanism analysis shows that MnO2 and Fe2O3 in pyrolusite were converted to (NH4)2Mn2(SO4)3, (NH4)3Fe(SO4)3, and NH4Fe(SO4)2 by roasting with ammonium sulfate. Iron was removed from the leaching solution with the addition of ammonia. Afterward, manganese carbonate products were prepared from iron-free manganese sulfate solution by adding ammonium carbonate at a stirring duration of 60 min, a reaction temperature of 40 degrees C, a pH of 7, and a molar ratio of ammonium carbonate to the manganese of 1.1:1, the precipitation efficiency of manganese could reach 99.8%, and the obtained manganese carbonate products were compliant with the industry standards. The ammonia released during the roasting process could be absorbed to regenerate (NH4)2SO4 and the final filtrate after evaporation and crystallization could be used to recycle (NH4)2SO4, both of which were used again into roasting process to reduce the consumption of raw material. In this process, the roasting temperature was only 420 degrees C, which was significantly lower than the pyrometallurgical process suggested in earlier studies.

Process of Techniques Researches on Low-grade Manganese Ore by Roasting with Ammonium Salt

Reduction of Low-Grade Manganese Oxide Ore by Biomass Roasting

Insight of Reduction Roasting of a Low-Grade Goethitic Indian Iron Ore in a Rotary Kiln: Process Optimization and Characterization

A Process for Extraction of Manganese from Manganese Oxide Ores by a Novel and Efficient Roasting-Acid Leaching Technique

An Environmentally Friendly Approach for the Extraction and Recovery of Mn from Pyrolusite by Ammonium Sulfate Roasting‐water Leaching and Ammonium Carbonate Precipitation

Individual enrichment of manganese and iron from complex refractory ferromanganese ore by suspension magnetization roasting and magnetic separation

Green and Efficient Utilization of Ferruginous Gibbsite Ore and Ferruginous Manganese Ore by Synergetic Carbothermic Co-Reduction–Magnetic Separation Process

The Extraction of Valuable Metals and Phase Transformation and Formation Mechanism in Roasting-Water Leaching Process of Laterite with Ammonium Sulfate

Novel Process of Reduction Roasting Manganese Ore with Sulfur Waste and Extraction of Mn by Acid Leaching

Ammonia removal and simultaneous immobilization of manganese and magnesium from electrolytic manganese residue by a low-temperature CaO roasting process

Ammonia Leaching of Zinc from Low-grade Oxide Zinc Ores Using the Enhancement of the Microwave Irradiation

A Novel Circulation Process to Effectively Produce Electrolytic Manganese Metal (EMM) with Low-Grade Manganese Oxide Ores and High-Sulfur Manganese Ores

Extraction of Various Valuable Elements from Oceanic Manganese Nodules using Coal Gasification Slag via Reduction Roasting-Acid Leaching Process

Efficient Extraction of Manganese from Low-Grade Pyrolusite by a Sawdust Pyrolysis Reduction Roasting-Acid Leaching Process

Study in Reduction-Roast Leaching Manganese from Low-Grade Manganese Dioxide Ores Using Cornstalk As Reductant

A Study of Recovery of Copper and Cobalt from Copper–cobalt Oxide Ores by Ammonium Salt Roasting

Research on Sodium Salt Roasting-Acid Leaching Technology for High-alumina and High-silicon Refractory Limonite

An efficient and green method to separate iron and manganese from ferromanganese ore by suspension magnetization roasting and magnetic separation

Comprehensive Recovery of Ni-Co from Low Grade Manganese Oxide Ore

Thermodynamics and Chloridizing Roasting Conditions of Laterite Through Ammonium Chloride

Research on the Process of Roasting Magnetic Separation-Acid Leaching for Oolitic Hematite Ore