Abstract:To study the shear characteristics of rubber-sand mixtures, the effects of four rubber-sand mixtures gradations（one type of gap gradation, two types of continuous gradations, and one type of open gradation）, three rubber contents（10%, 30%, and 60%）, and three vertical stresses（30 kPa, 60 kPa, and 90 kPa） on the strength characteristics and volumetric change characteristics of rubber-sand mixtures were investigated by using a laboratory large-scale direct shear apparatus; and based on the laboratory direct shear test, the discrete element numerical models of pure sand and rubber-sand mixtures were established according to the same gradation and rubber content. The intrinsic mechanical mechanism of rubber-sand mixtures was explored from the perspective of particle contact state and displacement. The results show that the shear stress curve of rubber-sand mixtures is the same as that of pure sand at low rubber content, but its shear strength is lower than that of pure sand; the shear stress of rubber-sand mixtures increases with the increase of vertical stress, and the shear strength of continuous gradation SR2 is the highest among the four gradations of rubber-sand mixtures; the admixture of rubber particles can effectively inhibit the dilatancy of sandy soil, among which the gap grade SR1 has the best effect on inhibiting soil dilatancy, and the dilatancyis reduced by 37% compared with that of pure sand. The internal friction angle of rubber-sand mixtures decreases with the increase of rubber content, and the internal friction angle of continuous gradation SR2 is the largest under the same rubber content; rubber particles mainly participate in the formation of weak force chain in the rubber-sand mixtures force chain network, and the shear zone width of rubber-sand mixtures is smaller than that of pure sand.

Experiment on Friction Characteristics Between Polystyrene Board and Coarse Sand

Experiment on Friction Characteristics of Polystyrene Board and Fine Sand

Experimental Study on Friction Characteristics of Polystyrene Foam Slab and Cushion

Experimental Study on Friction Characteristics Between Polystyrene Board and Geomembrane

Experiment of initial relative density effects on sand strength

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Laboratory Study of Interface Friction between Sand and Steel Surfaces

Experimental and Numerical Simulation Study on Shear Strength and Secondary Particle Breakage of Coarse Sand with Different Dry Densities

Performance Comparison and Mechanism Analysis of Several No-Bake Sand

Experimental study on the frictional capacity of square pile–cemented soil interface with different surface roughness

Experimental Study on Friction Capacity of Pile-Stabilized Soil Interface

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

Experimental Study on Mechanical Behavior of Sand Improved by Polyurethane Foam

Micromechanism study on the influence of particle deposition angle on mechanical properties of sand

Shear behavior of polyurethane foam adhesive improved calcareous sand under large-scale triaxial test

Effect of Young’s Modulus and Surface Roughness on the Inter-Particle Friction of Granular Materials

Simulation analysis and experimental research of friction performance between wood and cemented carbide surface with different micro-textures

Experimental investigation on the anisotropy of friction property for dry and water-saturated rock

Experimental investigation and discrete element method simulation on mechanical properties and failure mechanism of polymer-stabilized sand

Wetting characteristic and flow behavior of silicate binder at various sand particle-particle interfaces: Fine or coarse, circular or angular particles

Determination of the Effect of Soil Particle Size Distribution on the Shear Behavior of Sand