Abstract:There is a strong push in recent years for development of high-performance materials to be used in the hot-end components of aero-engines at temperatures beyond the operating range for nickel-based superalloys. The interest in silicides and silicide-matrix composites arises from their high melting points, ability of strength retention, along with impressive oxidation resistance at elevated temperatures, which are considered as desirable. Among the silicides, the molybdenum-, titanium-, and niobium-based multiphase alloys and composites have been found to be the most promising. Whereas MoSi2 has the best high-temperature oxidation resistance among the silicides, its ambient temperature fracture toughness as well as high-temperature strength retention are poor, and then, there are serious difficulties in near-net shaping of components. Therefore, starting from MoSi2 based composites with ceramic reinforcements, a significant attention has been paid during the last two decades to the development of multiphase Mo-Si-B based ternary alloys with bcc-Moss, Mo3Si, and Mo5SiB2. While crack-arrest and plastic deformation of the ductile bcc-Moss contributes to toughening, the presence of Mo3Si and Mo5SiB2 assists in retention of high-temperature strength, as well as formation of a borosilicate scale to protect against oxidation. In the multicomponent Nb-Si-X alloys, the presence of ductile Nbss is responsible for toughness enhancement, whereas the intermetallic silicides or Laves phases contribute to strength retention. This chapter will provide an overview of the crystal structures and phase equilibria in Mo-Si, Ti-Si, and Nb-Si based systems, processing methodologies, evolution of microstructure, mechanical properties, oxidation behavior, and potential applications.

Ultra-high Temperature Mo–Si–B Alloys — Synthesis, Microstructural and Mechanical Characterization

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Preparation and Properties of High-Temperature Mo-12si-8.5b Alloys

Effect of Si/B Ratio on the Microstructure and Mechanical Properties of Lanthanum Oxide-Doped Mo–Si–B Alloys

Mo–Si–B alloys for ultra-high-temperature space and ground applications: liquid-assisted fabrication under various temperature and time conditions

Alloy Designs for High Temperature Mo-base Systems

The Multi-Scale Microstructure and Strengthening Mechanisms of Mo-12Si-8.5BxZr (at.%) Alloys

Developing a uniform distribution of bimodal α-Mo grains in the Mo–Si–B alloy for toughness and strength improvement

From Mo–Si–B to Mo–Ti–Si–B Alloys: A Short Review

Optimizing the microstructure and mechanical behaviors of bimodal Mo-Si-B alloy by heat treatment

Microstructures and Mechanical Properties of Ti–44Al–5Nb–3Cr–1.5Zr–xMo–yB Alloys

The progress in preparation and properties of multiphase Mo-Si-B alloy

Synthesis, microstructure and properties of MoAlB MAB phase films

Preparation, microstructure and mechanical properties of MoAlB-0.15% Si ceramics with superior strength and toughness

Cooperative Effects of Mo and B Additions on the Microstructure and Mechanical Properties of Multi-Elemental Nb-Si-Ti Based Alloys

Microstructure and compression properties of fine Al2O3 particles dispersion strengthened molybdenum alloy

Preparation of fine-grained Mo–12Si–8.5B alloys with improved mechanical properties via a mechanical alloying process

Silicides and Silicide Matrix Composites for High-Temperature Structural Applications

Characterization of Mo–Si–B Nanocomposite Powders Produced Using Mechanical Alloying and Powder Heat Treatment

High temperature tribological behavior of Mo–12Si–8.5B alloy reinforced with MoAlB ceramic

Review of Research Progress on Mo-Si-B Alloys