Abstract:We investigate the morphology of and surface modification by titanium dioxide (TiO 2 ) deposits on porous ceramic substrates placed in a horizontal, tubular, hot-wall, atmospheric pressure chemical vapor deposition (CVD) reactor with titanium tetraisoperoxide (TTIP) as the precursor. The TiO 2 particles are produced from TTIP through two routes: first by thermal decomposition which then kicks off hydrolysis. The deposit characteristics is found to be location dependent. Those at the reactor entrance and exit are different from that within the reactor. Within the reactor, the deposit characteristics is further found to depend strongly on the deposition temperature (T d ) and is almost independent of the flow-rate and concentration of the reactant. With a T d of about 380 °C, the deposited TiO 2 forms a forest-like structure with poor adhesivity to the substrate and results in an insignificant pore size reduction for the substrate. If T d drops down to about 300 °C, the deposited TiO 2 forms a rock-packing structure with good adhesivity to the substrate and can reduce the pore size of the substrate from about 1–2 μm down to about 64 nm. At both the reactor entrance and exit, the deposited TiO 2 are loosely-packed spherical particles of average diameter of 140–400 nm. A theory, based on whether or not the reaction is gas-phase or surface dominated, is proposed to explain the dramatic effect of T d .

Coating and Characterization of Titania Membrane on Porous Ceramic Supports

Effect of Type and Content of Pore-forming Agents on Properties of Porous Alumina Membrane Support

Preparation of a High-Performance Porous Ceramic Membrane by a Two-Step Coating Method and One-Step Sintering

Preparation and Sintering of Macroporous Ceramic Membrane Support from Titania Sol-Coated Alumina Powder

Preparation and properties of supported 100% titania ceramic membranes

Effect of TiO2 modified layer thickness on the properties of PVDF-TiO2 membrane

Preparation and characterization of tubular porousα-Al_2O_3 ceramic membrane support

Fabrication of alumina ceramic membrane supports using LCD 3D printing and titania nanoparticle doping

Preparation of Porous Ceramic Support with Inorganic Filtration Membrane

Study on surface morphology of porous ceramic membranes

Relation Between Porosity and Permeability of Ceramic Membrane Supports

Facile surface modification of ceramic membranes using binary TiO2/SiO2 for achieving fouling resistance and photocatalytic degradation

Preparation and mechanism analysis of high performance ceramic membrane by spray coating

Preparation and Characterization of Porous Alumina Ceramic Membrane Support

Preparation of asymmetric pure titania ceramic membranes with dual functions

One-step Coating and Characterization of Α-Al2o3 Microfiltration Membrane

Morphology of and surface modification by TiO2 deposits on a porous ceramic substrate

Porous titania surfaces on titanium with hierarchical macro- and mesoporosities for enhancing cell adhesion, proliferation and mineralization.

(MgCoNiCuZn)O-coated ceramic membrane: Preparation, microstructure, and properties

A study of top layer of TiO2 membrane prepared by chemical vapor deposition method

High-performance Macro-Porous Alumina-Mullite Ceramic Membrane Supports Fabricated by Employing Coarse Alumina and Colloidal Silica